Recent content by AznTactical

Jman, I'll take it.

Can you tell me step by step how you checked your total elevation? Emailed Steiner on their procedure twice and nothing back. I tried and I spun it the wrong way where there was less than 3 mils above zero. (I had to spin the inner turret to get it back and scratched the white lock/unlock...

Don't recall Malum having an issue? OCD is definitely me for sure.

This is what TT sent me when I started going full auto. See where I underlined in red. I just want to clarify that this issue started happening around the 180-190th round mark. Sometimes it would not recock. Most of the time it would double or triple tap. Approximately 3-4 times it went...

yes, it was either on that thread or in this thread. Very similar problems with trying to figure out how their zero stop works and manual sucks. Should be easy peasy but I guess it's easy to go full retard. Zero stop isn't the issue here I think. It was trying to find the full advertised 35...

20 moa is on 6 ARC, 20 moa pic rail on 22lr when it was on the 22. Coincidently the available mils left to dial was very similar.

Long story, long, I bought it for 22lr long distance shooting so I wanted to take advantage of every mil available. With a 20 moa rail and a 50yd zero I had about 23 mils available to dial. So that means I have 12 mils wasted because specs are claiming 35 mils total. I upgraded the 20 moa...

I'm asking for advice so I'll take it. However, yes, 1st thing I do for every optic I get is verify that total elevation and windage meets their specifications. With the turret lock off, I can get 11 mils of windage (5.5 left and 5.5 right). Advertised is 15 mils. Repeat for turret and...

Yes, 3-18, sorry should of clarified.

I have 3 times with my 3-18x56. 1st attempt-Missing torx screw on elevation turret (brand new unit). (submitted case and after 7 business days I called myself). -They sent me the torx screw. No torque info. Contacted them again and finally got a torque value. 2nd attempt-Torx screw broke...

12X it's very hard to tell because I ran out of horizontal #'s on each end but looks to be right around 36 mils. 18X is 23.6-23.8 mils.

Too early to tell for me yet. Only 150 rds through my LTi so far. So far so good. It's hard to remove off the host when hot (My 1st direct thread can). Needs a slim 13/16" wrench to crack it loose. However, a guy on FB had his new STi's weld break before he even fired it.

I used Thunderbeast's Summit Report to determine what I wanted for another can. Priority was weight, cost, db reduction and availability. Overall size was NOT a factor. The Enticer LTi got my money. I sorted their data by dBA as a starting point. For ref the Omega with flat cap was only...

"autofire". I know this all to well. Happened to my 6 arc AR build using their Diamond 2 stage. Started happening after 200rds. Had to adjust the trigger up to over 34oz to make sure autofire wouldn't happen. They told me "sorry, here's the faq on this issue and clean it with lighter...

Here's my new Diligent Defense Enticer LTi next to my 8+ year old Omega. Both have very different point of uses. Omega feels and looks to be more durable. I've had the classic Omega baffle strike before. Have seen 2 guys at the range launch their Omegas too. For duty use Omega is my choice...