Recent content by Hondo1

As far as I know yes it did. It was basically an adjustment to the current dimensions of ADG brass.

Just wait for the CDG and get a 7mm PRC barrel, it’s the new 7mm easy button. I sweated over 7mm’s for quite some time and finally had landed on the 7ss right about the Rich changed the reamer dimensions. After that I said piss on it and went PRC and have never looked back. If you truely are...

Try Hornady One Shot

3 2 1

26 with a suppressor

Been a minute since I started this thread, I ended up going 6mm Creedmoor. Rifle is put together and I am working on load development with the 80gr VT. While running loads up looking for pressure I saw a little over 3500fps. Flat primer though so I’m going to play in the neighborhood of 3400ish...

They are to long, you will need a 1:8”

up

up

The 108 is a turd on p-dogs. On paper the 80 is the best of both worlds. Explosive performance on soft tissue, speed, and enough BC to have fun at distance. Time will tell if it works out as advertised.

In my case this rifle is only for killing prairie dogs and coyotes. I want flat, fast, and explosive.

26” barrel, h4350, 80gr VT,Prime brass. I did a quick pressure work up from 43.5 to 46.0 @ 46.0 primers were slightly flattened, no ejector swipes or any signs of brass flow, 3508fps average with 46.0 I’m going to work from 45.0 - 45.5 and see what groups look like next.

80gr VT left, 87gr Vmax right

Just had 500 80gr VT’s delivered today. I’ll start load workups soon

Anyone try the 62gr eld-vt’s yet? I’m. Looking for a starting load with Varget.