Recent content by Rstrick0352

Up top

Up top

Sold

https://www.cncwarrior.com/Barrel-Crowning-Tool-p/25453.htm You just buy a pilot for the corresponding caliber you’re looking to crown. I’veused this when I cut down AK barrels and it does a fine job.

Midway USA prefit cut down to 16”, threaded 5/8x24. 1-10 Twist. Approx 800rds fired. Absolute hammer. Heavy Varmint, Shilen S7 contour. Comes with blued barrel nut and thread protector. $200 shipped, Paypal F&F, you cover the fees. $220 if you would like a stainless PVA barrel nut instead.

Everything you need to true your small shank (long and short) actions at home with hand tools. This essentially mimicks the popular Manson kits for Remingtons and uses pilot bearings situated in the bolt raceway to reference the tools. I have used this to true 5 actions so everything is in like...

I gotcha. I don’t want to highjack the thread any further, I just wanted to get rid of all I have.

I have 8x unopened boxes 100ct of 178 amax and an open box that is still quite full. $200 shipped if you want them.

It is most likely Mk248 mod 1 and that being the case, was a significantly over pressure load. I have reloaded it but every primer pocket was loose from the one firing prior. The loads were precise but I did not dare attempt a third loading.

Enroll in the Roth TSP with at least 5% contributions and as soon he is able, adjust the disbursement into the indexes and out of the G fund (it all defaults to the G fund which is the worlds shittiest savings account). I began using the TSP way too late in my career and have major regrets.

Sold

Word. Shot you a PM.

Used but still perfectly serviceable with all the required hardware. $100 shipped; PayPal or Venmo only.

Would you consider a Battleline Industries (Magpul) SAPR or a PWS Gen 1 enhanced buffer tube in trade for the LuthAR?

I have 4: 300wm, .308win, 6.5cm (5R) and a 22cm and all are fantastic shooters. Buy with confidence.