- Thread starter RFutch
- Start date
Looks like an old gen KRG Whiskey 3 with their enclosed forend. Here's what they have now https://kineticresearchgroup.com/product/enclosed-forend/
Whole chassis is new I bet. Which means it isn’t available to the public yet
@CaylenW @velayo_0317 they might know but looks awesome.
Could be pulling this out of my ass but I think its a new Vision forend for the KRG. I know I have seen pictures somewhere of one that looks a lot like it.
must be from cali... who shoots without suppressors??
Last edited:
Sorry gents, direct your questions to KRG. I've been explicitly instructed to, and I quote, "don't say shit to nobody..."
Looks kind of like a mix of the Habu and the W3 with some AIAT-X features thrown in for good measure. Looks awesome to me.
I seen mention that it's a prototype in response to a comment on one of Caylen's/moderndaysniper Instagram posts.
Paging @Massoud again. The cat is out of the bag, so you might as well give us all the details right? 
I ROd that match and was told it’s a prototype. It would definitely be nice to be able to add external weights and have MLOK on a KRG
You could do that with the W3 enclosed forend.
I should clarify to be able to place the weights low enough to add width to the bottom of the forend. Like the ACC and MPA comp chassis
Double negative which means you can say shit to everyone. Always best when people use the most gooderst English
If no one else will let the cat outta the bag, I guess I'll have to.
Quigley Ford finally entered the chassis market!
Quigley Ford finally entered the chassis market!
Well crap, I just ordered the 'old' enclosed forend for my project. This may explain why I had to find the corresponding ARCA rail in the PX, they were out of stock on the KRG website and they said they had no ETA when it would be available. Clearing stock???
I am no man....What if YOU are considered a NOBODY?...
I like it for a dedicated PRS/NRL match type rifle; it's most definitely purpose built for that. For everything else though, the W3 is my go-to.
Anyone know or is allowed to say if the new chassis is going to be clearanced for a Trigger hanger? specifically IMpact 737SA.
Thanks!
Thanks!
I heard it was just the Whiskey Gen 7. Does the Gen 6 support a trigger hanger? Or was that an ask for the Gen 7?
It was just a general question about the new chassis and if it would be clearanced for a tirgger hanger. I don't keep up with what ever is the latest and greatest Gens or revisions unfortunately.
I have a KRG Bravo for my ARC actions currently, but I wouldn't mind getting another KRG that is clearanced for a trigger hanger so that I don't have to Dremel Smith it out.
I didn't pay that close attention to it because I don't run trigger hangers, but I'l have a look-see tomorrow and get back to you.
Anyone have any details on this chassis ? Release date ?
