I took my rifle apart to clean off the krylon that was on there before. This is on a remington 700 action with a Hubber concepts trigger with top safety and AI 2.0 chassis. I tried to put it together and the trigger would not release the firing pin and the safety would not go backwards. I removed the trigger and it seems fine. Put it back and it binds again. I started to tap the two pins holding the trigger in place and it works. tap it a little more and it stop working. Has anyone ran into this issue? Thanks in advance. It is very frustrating.
Gunsmithing strange trigger binding problem...please help
- Thread starter turbohardtop
- Start date
Re: strange trigger binding problem...please help
You're pinching the housing when you drive the pins in. I do this on every install. Install the front pin completely so nothing is in a bind then the rear. Take a punch and on the rear of the housing lightly move each side of the housing to the outside. I sometimes use a screwwdriver the right size, insert and give it a twist to spread the housing. Should solve your problem.
You're pinching the housing when you drive the pins in. I do this on every install. Install the front pin completely so nothing is in a bind then the rear. Take a punch and on the rear of the housing lightly move each side of the housing to the outside. I sometimes use a screwwdriver the right size, insert and give it a twist to spread the housing. Should solve your problem.
Re: strange trigger binding problem...please help
thank you Dave. I was guessing this as well. I will take a look at it more later when I get home.
thank you Dave. I was guessing this as well. I will take a look at it more later when I get home.
Re: strange trigger binding problem...please help
Could someone confirm the size of the front sear pin and the bolt stop pin. I noticed one is longer than the other.
Could someone confirm the size of the front sear pin and the bolt stop pin. I noticed one is longer than the other.
Re: strange trigger binding problem...please help
Short one up front and drive it in till it clears the bolt stop groove.
Short one up front and drive it in till it clears the bolt stop groove.
Re: strange trigger binding problem...please help
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Dave Tooley</div><div class="ubbcode-body">Short one up front and drive it in till it clears the bolt stop groove. </div></div>
Drive is such a harsh word....I tap in my trigger pins
Looks like Dave has you on the right track, I just hard to chime in to be a smart ass.
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Dave Tooley</div><div class="ubbcode-body">Short one up front and drive it in till it clears the bolt stop groove. </div></div>
Drive is such a harsh word....I tap in my trigger pins
Looks like Dave has you on the right track, I just hard to chime in to be a smart ass.
Re: strange trigger binding problem...please help
Being a smart ass is an affliction we all have. Some of us are just more talented than others.
Being a smart ass is an affliction we all have. Some of us are just more talented than others.
Re: strange trigger binding problem...please help
thanks everyone. I did have the pins in correctly then.
thanks everyone. I did have the pins in correctly then.
Re: strange trigger binding problem...please help
I looked at the trigger again and it was somehow "bind" to one side of the wall of the action. I manage to center it and all is good. Thanks again.
I looked at the trigger again and it was somehow "bind" to one side of the wall of the action. I manage to center it and all is good. Thanks again.
Similar threads
