Does anybody else have problems getting the targets to print to the right size? I have been shooting the Tac 50 target and finally decided to measure my circles... the 3/4 group challenge was barely over 1/2" - that's when printed on my printer at 100%
If I print them then copy them at 120%, the circle sizes are correct (for know your limits, they are the proper 1", 3/4", 1/2", 1/4" - and the Cold Bore is 1/2" black center and 1" overall)
Same with the 25 yd 4 position targets...
I can't find the proper 7X size for the 100 and 200 yd Lucky 7 targets so I can double check them also... does anybody know what size they are supposed to be?
I don't want to use these if that's incorrect, but it was the only way to get the sizes to match what was listed on the bottom of the "Printable Targets" page.
Does that sound right to anybody?
They sure look much bigger after shooting them before when everything was smaller...
Slick
If I print them then copy them at 120%, the circle sizes are correct (for know your limits, they are the proper 1", 3/4", 1/2", 1/4" - and the Cold Bore is 1/2" black center and 1" overall)
Same with the 25 yd 4 position targets...
I can't find the proper 7X size for the 100 and 200 yd Lucky 7 targets so I can double check them also... does anybody know what size they are supposed to be?
I don't want to use these if that's incorrect, but it was the only way to get the sizes to match what was listed on the bottom of the "Printable Targets" page.
Does that sound right to anybody?
They sure look much bigger after shooting them before when everything was smaller...
Slick