Ok so I have a Couple Bell And Carlson stocks on a short action and long action 700. I really like the vertical grip but the foreend is just too wide and flat. What stock has the vertical grip but has a better foreend. I was looking at the manners but it is hard to tell from pictures and thats alot of money to get the samething I have. Thanks a lot.
- Thread starter CLNDESL
- Start date
Re: Vertical grip stocks
I really like the McMillan A-3, I assume the Manners T2 is somewhat similar.
I really like the McMillan A-3, I assume the Manners T2 is somewhat similar.
Re: Vertical grip stocks
+1 for McMillan
+1 for McMillan
Re: Vertical grip stocks
Might want to look at the new Manners T6-A
Might want to look at the new Manners T6-A
Re: Vertical grip stocks
I will check these out thanks for the suggestions. I like the mcmillians but the wait always changes my mind. Thanks again.
I will check these out thanks for the suggestions. I like the mcmillians but the wait always changes my mind. Thanks again.
Re: Vertical grip stocks
I'm waiting on a mcmilan myself... the wait blows
I'm waiting on a mcmilan myself... the wait blows
Re: Vertical grip stocks
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Duffy1298</div><div class="ubbcode-body">I'm waiting on a mcmilan myself... the wait blows
</div></div>
Same here, or rather my smith is. I was quoted 16 weeks, ouch.
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Duffy1298</div><div class="ubbcode-body">I'm waiting on a mcmilan myself... the wait blows
</div></div>
Same here, or rather my smith is. I was quoted 16 weeks, ouch.
Re: Vertical grip stocks
I've been considering using like a 1/2" or 3/8" round over but in a router on my B&C A5. Just the forearm section that is wider that the action block area. I know there will most likley be some air pockets and will open up some voids but I thought just fill them with Devcon then texture it over the top.
I would like to produce something like a beaver tail forearm or like the McM A5
I've been considering using like a 1/2" or 3/8" round over but in a router on my B&C A5. Just the forearm section that is wider that the action block area. I know there will most likley be some air pockets and will open up some voids but I thought just fill them with Devcon then texture it over the top.
I would like to produce something like a beaver tail forearm or like the McM A5
Re: Vertical grip stocks
I've read on here that Manners will send you a stock to look at before they make yours.
I've read on here that Manners will send you a stock to look at before they make yours.
