hi guys,
Im trying to reload for my semi 308 and im using a redding body die to resize the brass due to it not fitting in a Wilson case gauge well (the lip of the shell stick out).
I was told that the body die should bump the shoulder back too, which is what i probably need to do since it not fitting in the gauge correct right?
so as im doing this i check my once fried brass in an rcbs mic and its readding one thousand over zero (.001).. so i run it though the redding body die using a Forster press.. i take the casing out and measure it again, now its reading .003 in the rcbs mic..and its still not fitting into the Wilson case gauge correctly..
what am i doing wrong? when bumping a shoulder back shouldn't my mic be reading the shell less than .001 since it was .001 before the resize?....please help..thanks..
Im trying to reload for my semi 308 and im using a redding body die to resize the brass due to it not fitting in a Wilson case gauge well (the lip of the shell stick out).
I was told that the body die should bump the shoulder back too, which is what i probably need to do since it not fitting in the gauge correct right?
so as im doing this i check my once fried brass in an rcbs mic and its readding one thousand over zero (.001).. so i run it though the redding body die using a Forster press.. i take the casing out and measure it again, now its reading .003 in the rcbs mic..and its still not fitting into the Wilson case gauge correctly..
what am i doing wrong? when bumping a shoulder back shouldn't my mic be reading the shell less than .001 since it was .001 before the resize?....please help..thanks..