Anyone using STM's 40# tumbler?

[Mag 300]

looking for a new tumbler and might buy the STM "sponsor here" 40# tumbler. but its $698 or $799.00 for the package . then shipping is over $100.00?

is there another unit just as good or better for same or less cost?

Wanted to know if its a well built unit that will last?

Thanks Bill

 

[Deadshot2]

Re: Anyone using STM's 40# tumbler?

When I want to tumble that much brass I'll just go buy a small cement mixer and have the inside sprayed with Rhino Bed Liner.

Local shop want's $100 to prep and spray. The "mixers" are available for around $150

Here's what I'm describing

Capacity is over 100#

 

[Mag 300]

Re: Anyone using STM's 40# tumbler?

Deadshot thanks just can across a great deal on a pacific commercial 3 bin tunbler , its new and built to last so just bought it
Thanks Bill

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Deadshot2</div><div class="ubbcode-body">When I want to tumble that much brass I'll just go buy a small cement mixer and have the inside sprayed with Rhino Bed Liner.

Local shop want's $100 to prep and spray. The "mixers" are available for around $150

Here's what I'm describing

Capacity is over 100# </div></div>

 

[jmtgsx]

Re: Anyone using STM's 40# tumbler?

Is this pacific commercial 3 bin tunbler deal available to others?

 

[Mag 300]

Re: Anyone using STM's 40# tumbler?

I got it on ebay there was only one you can check but here is a link to the type it is .
$650.00
http://www.youtube.com/watch?v=4WtdaK2NxAg


<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: jmtgsx</div><div class="ubbcode-body">Is this pacific commercial 3 bin tunbler deal available to others? </div></div>