Question about manners stocks

[GhostFace]

I was looking at a t4 at stockys and they only have the varmint contour but I have a Rock M40 blank, is that too big for the varmit t4?

 

[strike33]

The m40 blank will be too big. Word has it that the Manners inlets run on the tight side as well

 

[SporterII]

Not uncommon to relieve it to fit barrel contour.

 

[GhostFace]

To relieve it, would that require alot of smith work?

 

[strike33]

Its not much, especially if you are having it bedded.

 

[GhostFace]

Okay thnx!

 

[Danley]

Less than 15 minutes with a wooden dowel or socket wrapped in sandpaper and it'll drop in.

 

[SporterII]

Less than 15 minutes with a wooden dowel or socket wrapped in sandpaper and it'll drop in.

If the chamber end is the same length. Some profiles are longer in that greater dimension.
Call the stock maker and ask how much work is involved and where they would direct you for finish inletting.

 

[Danley]

If the chamber end is the same length. Some profiles are longer in that greater dimension.
Call the stock maker and ask how much work is involved and where they would direct you for finish inletting.

I went from a varmint / sendero contour to a heavy varmint contour (1.25" for the first 5") with ease on my T4 with only a deep well socket and sandpaper.

 

[Pinecone]

How is the inside of the barrel channel finished? What material?