• Watch Out for Scammers!

    We've now added a color code for all accounts. Orange accounts are new members, Blue are full members, and Green are Supporters. If you get a message about a sale from an orange account, make sure you pay attention before sending any money!

  • The site has been updated!

    If you notice any issues, please let us know below!

    VIEW THREAD

Loads for .204 Ruger

Point of Impact

Private
Minuteman
May 1, 2012
22
0
34
I am just working on .204 Ruger loads and I need some help working up some loads. I would like to get some of your opinions on your load data as well. Figured more than just I will use it too.

40 gr Hornady V-Max
27.5 gr H4895
2.295" OAL.
Hornady Brass
Winchester Primers
Need to Chrono them still since the last one I had has issues with small fast rounds.

If it was possible to share powders with my .308 that would be great but it isn't a problem so I am not focused on that.
 
I'd like to know of a good load for the .204 also. Got two to plink around with and hope to do a little varmint hunting later this spring.
 
Shot both factory loads by hornandy, 32 and 40 grn vmax. Both have produced great results. Coping it would work great for him, maybe for you as well. Good luck
 
Rem xr-100 rangemaster 26" 1:14 twist:
39g sierra blitzking
2.39 coal
30.0 grains bl-c (2)
Hornady brass
Win primers
Avg 3880 fps @ 1104' asl 52ºF

This is the best load I have found. Consistently .2 or less. Best was .067" 3 shot 100yd. Last time out I fired 2 shots at 300yds measuring .097". It also shoots extremely well in my shooting partners howa. His 3 shot measured 0.238 100yd. Use caution and work up. 30.3g pierced primers. Less wind drift than my 223 load with 55g vmax.

Varget grouped well also but lacked speed as the hottest load I tried only ran 3650 fps. Case was full. My rifle was very fun in load work up. Nothing shot over .4" under the 39g bk.
 
29.8 gr blc-2 and your choice of 40 gr bullet I prefer berger hp. This is my load in 2 rifles, 1 rem and 1 ar. H-335 gave great accuracy too. Using win and hornady brass with cci small rifle mag primers. Tis is death on anything I have touched with it inside 400 yards including coyotes and further on prairie dogs. Shot steel to 650 with good accuracy and 1k with not such good accuracy (too much wind drift)
 
Sorry to side track slightly...but have you guys noticed any difference between the 32gr and 39/40gr bullets on prairie dogs, as far as the effect (splat factor, red mist, whatever you want to call it)?
 
32 vmax at ranges inside 150 gets pretty messy. The 40 gr berger is not pelt friendly but coyotes don't get up and walk away like they've done with vmax in my experience. Never had good accuracy with the blitz king in load development so I have no experience with it on game f any kind.
 
27.4 grains of 8208 does good in my DTECH ar15. 35 grain Berger rem 7.5

5 shot group at 100
5d3ce35a.jpg
 
some good info here. i have been working up 204 loads, too. recently got a ruger #1, and liked the round, so i have been rounding up stuff for a remington 700. with the current component craziness, i have just been working with what i have on the shelf. i am looking forward to some return to "normalcy", so i can actually try some different "recipes".
 
I shoot a 204 1in12 18" barrel Bushmaster ar
39 g Blitz King
26 g Benchmark
2.26 Coal

The Bk was grouping tighter than the vmax
 
I have had mine since 2006 Ruger M77 Varmint 28" Barrel ,I mostly use FED M205 primers but use BR4's, I prefer them for a bolt action rifle

1. BL-C2 28GRNs
40 grn Hornady Remington Case CCI BR4 primer
2. RL-10X 25 Grn's Barnes VG 26 Grn's FED 205 Primer, case Hornady
This is just some of my loads, I have 3 204's ( I have twin boy's) I also like the Hornady 45 grain bullets they shoot good and kill yotes dogs what ever you hit love my 204
 
I've experimented with Nosler & Hornady 32gr & 40gr (Varmageddon 32gr HP & 32gr & 40gr V-Max/ Z-Max) simply from an availability & cost-effectiveness standpoint as some of you have mentiuoned. Have a 7MM and a .243, was hoping to consolidate to one powder but no luck there so- again, for availability- I use IMR4985. Here are my specs:

Hornady brass
CCI BR4 primers
27 grains IMR 4985.
*Good results with the Nosler 32gr, Hornady 40gr were also good but needed near-max charge of 27.6 (compresses at 27.8) gr powder (barrel pressure 56,000 is more than I want) so I focused on Hornady 32 Vmax/ Zmax (the 32 V & Z are same bullet once you compare all the specs). They are working best so far. Got 1,500 Zmax at $13.00 per 500, so couldn't pass that up. I have them grouping (when I am consistent) at 0.75-0.85 inch at 200 yards, then from 0.8 to 1.2 at 300 (using Leupold VX1 4x12 with BDC reticle). Rifle is a Remington 700 SPS with a Hogue stock I added extra glass bedding to and a Shilen 1-3 lb trigger at 2 lbs. As it is still sporadically snowing & about 23 degrees max when I shoot on Saturdays in Montana, I am convinced I am the main negative variable and plan to obtain a lead-sled to complete final honing-in and zeroing. No coyotes yet, but the 6" steel-plate gong at the range's 300 yard marker swings every time... :) Ideas/ feedback/ practical results of your own are welcomed- share your recipes!
 
Remington XR 100
Hornady or Win Cases
40 gr V-max
25.8 gr TAC
or
25.5 gr X-terminator

Both produce great 5 shot groups in the .150-.200 range and run in the 3750 ish range.
 
Small Rifle Primer Rankings & 0.5 MOA at 600m From .204 Sako 85 Varmint

I am just working on .204 Ruger loads and I need some help working up some loads. I would like to get some of your opinions on your load data as well. Figured more than just I will use it too.

40 gr Hornady V-Max
27.5 gr H4895
2.295" OAL.
Hornady Brass
Winchester Primers
Need to Chrono them still since the last one I had has issues with small fast rounds.

If it was possible to share powders with my .308 that would be great but it isn't a problem so I am not focused on that.

----------------------------------------------

G'day POA = POI,

Although a couple of years behind the play, in late afternoon, cool (no mirage), still conditions, using our .204R stainless fluted Sako 85 varmint with set-trigger, laminated stock, Harris bi-pod, rear sandbag (on the bench) and a 5-25x56 S&B PMII SFP Illum. P4 Fein, we recently fired the following 204R hand loads, using FL resized, new Hornady brass that had been primed with Winchester No. WSR primers and set to a .010" jam seated OAL:

32gn Nossler Ballistic Tip Boat Tail (26.8gn of AR2219 gave 3,530fps)
40gn Hornady V-Max Boat Tail (24.0gn of AR2219 gave 3,307fps)
45gn Hornady SP Flat Base (23.0gn of AR2219 gave 3,136fps)

These loads were hand-fed, zeroed and CED chrony'd at 100m, then checked for dispersion at 600m, with Hornady's 32gn Factory ammo used as the baseline performance reference.

Surprisingly, the best group at 600m was 0.5 MOA from Hornady's 32gn Factory ammo, followed by 0.7 MOA at 600m from the 40gn V-Max. As anticipated, no further long-range work will be done with Hornady's 45gn SP Flat Base.

Warning - potential grassfire info to follow!

For wider reader interest, the best Small Rifle Primer performance, i.e., largest relative energetic output with smallest spread from my purpose-built, thermostatically controlled .22 Cal. primer kinetic energy test rig, came from Winchester's No. WSR primer with a relative energetic output (0.5 x m x v^2) of 9.33 Joules and an SD of 2.52m/s (averaged over 10 sequential shots).

Surprisingly, the worst Small Rifle primer performance came from the CCI BR-4 primer with a relative energetic output of just 5.73 Joules, but more importantly, an SD of 6.69m/s.

If I simply rank Small Rifle primer performance based on my observed, quantitative energetic outputs, the order looks like this:

Remington No. 7½ 10.52 Joules / SD 4.31m/s
Winchester No. WSR 9.33 Joules / SD 2.52m/s
CCI 450 7.93 Joules / SD 6.12m/s
Federal GM205M 7.30 Joules / SD 3.17m/s
Federal No. 205 7.18 Joules / SD 3.52m/s
CCI 400 6.34 Joules / SD 5.08m/s
CCI BR4 5.73 Joules / SD 6.69m/s
TulAmmo KVB-223 5.71 Joules / SD 4.00m/s
Fiocchi 4.92 Joules / SD 5.24m/s

However, in terms of uniform Small Rifle primer performance, the order now looks like this:

Winchester No. WSR 9.33 Joules / SD 2.52m/s
Federal GM205M 7.30 Joules / SD 3.17m/s
Federal No. 205 7.18 Joules / SD 3.52m/s
TulAmmo KVB-223 5.71 Joules / SD 4.00m/s
Remington No. 7½ 10.52 Joules / SD 4.31m/s (This Primer Lit Up Like An F-16 Jet Engine In Afterburner Mode)
CCI 400 6.34 Joules / SD 5.08m/s
Fiocchi 4.92 Joules / SD 5.24m/s
CCI 450 7.93 Joules / SD 6.12m/s
CCI BR4 5.73 Joules / SD 6.69m/s

Based on these 'no expense spared' experimental results, Winchester's No. WSR primer at 9.33 Joules and SD 2.52m/s is the all round best performer, with Federal's GM205M a more than respectable second.

Note: from my related research into Small Pistol primer performance, from which Remington's No. 5 1/2 was the best with an energetic output of 10.49 Joules and SD of 2.06m/s, the minimum impact energy to function these different primer types can be expected to range between 0.050 Joules and 0.080 Joules.

Primer manufacturers who have undertaken competitor product analyses on their own primer impact test rigs will find no surprises here.

Cheers from the Great Land Down Under.
 
Last edited:
In my experience, in regards to the .204...speed is your friend. I like the 32gr Sierra's, otherwise, if you go too heavy (like 40gr) you may as well go with a 22-250 because you start departing from what makes the .204 a .204.:D At 4130fps, I have found it to flat out anchor coyotes with authority, out to 350.. possibly more. Moving on... 32gr sierra blitzk, trim case 1.84", OAL 2.34", federal small rifle match primers, 27gr REL-10x. I would suggest as always, start low and work up to 27. As a side note, I experimented with many seating depths, starting as far out as I could go without the bullet falling out of the brass, all the way down to 2.34OAL and noticed no change in accuracy.
 
Last edited:
Anyone shoot the 55 gr bergers? I’ve got some RL15 and imr 8208 xbr I’m gonna try. Just looking for a starting point.
 
My unscientific field terminal effects experiments on prairie dogs favored 39gr blitzkings over 32gr Bullets in the .204. (More hang time).

I had good luck w/ 28.3gr of 748, Remington 7.5 and either 39gr BlitzKings or 40 gr vmax's in multiple rifles.