Rifle Scopes Cat-tail for Vortex 1-4 PST? ?

[Saito]

I've put a little research into this and can't find a cat tail for my Vortex.

Looked at Charlie Drissel:

Cat Tails ? The Perfect Throw Lever? | RecoilSports

Charles Drissel - Brian Enos's Forums... Maku mozo!

Any suggestions from you guys ? ?

 

[ORD]

According to the fine folks at MGMSwitchview, the following one should work on ALL Vortex Viper PST models, including the 1-4x:

Model 1692SV2R3V1 - Switchview? Lever [1692SV2R3V1] - $59.95 : MGM Switchview, The fastest and easiest way to adjust your power setting!

I have not used one personally on a 1-4x model, but they do a good job on the others. Do check with the usual Hide vendor sources for them before you buy from outside.

 

[CMH]

Vortex Optics - Switchview Throw Lever SV-1<br />Select Vipers

 

[bunsen27]

I run this on my vortex 1-4x and prefer it over the MGM's I use on my PST's

Amazon.com: Breakaway Nylon Coasters: Sports & Outdoors

 

[flounderv2]

Yes get the one by Vortex, for Vortex. Guessing you put less research into it than you thought.
Vortex Optics - Switchview Throw Lever SV-1<br />Select Vipers

 

[Saito]

That's what I'm looking for. Didn't navigate the Vortex website long enough to find it.

I always look to a hide vendor before going anywhere else.

Thanks for the responses everyone.

 

[jrob300]

Do you have the rubber mag ring (1.669" DIA.)? Then the SV-1 will work for you. If you have the newer metal mag ring (1.739" DIA.) then you need the SV-2.

Just learned this the hard way.

John

 

[Ring]

DIY cat tail or switchview for scopes, 2 for 20$ - Blogs - Sniper's Hide Forums