Rifle Scopes Lowest 34mm rings?

[jonthomps]

I've got a 300WM with a Badger 30moa base and a Bartlien #4 contour barrel. Just bought an S&B 3-20 w/ a 50mm objective and I need rings lower than 1-inch height. I've seen Seekins makes a set of .920 rings. I'm thinking an .885 or similar would set me as low as I can go. Anyone know of any lower?

 

[19Scout77]

The turret housing on the 3-20 will most likely interfere with the badger rail with any rings lower than 1". To answer your question, APA makes the only 34mm rings lower than the Seekins .92".

 

[jonthomps]

That's what I needed. Thanks!

 

[lifebreath]

There's less than an eighth inch between the bottom the turret housing of my 3-20 SB and the base with 1" high badger rings. Probably about 3/32 or .090.

 

[hamstur]

I tried to mount my SB 3-20 in Seekins 0.92" rings -- the bottom of the turret house WILL interfere and touch the base.

 

[phxfa]

I tried to mount my SB 3-20 in Seekins 0.92" rings -- the bottom of the turret house WILL interfere and touch the base.

some do, some dont, Ive had both

 

[jonthomps]

some do, some dont, Ive had both

I ordered a pair of Seekins 0.92" rings so here's to hoping my scope doesn't touch, lol

 

[JL]

I recall Spuhr SR-4000 is 1" high. Should leave clearance.

 

[19Scout77]

I had .0015" clearance with seekins .92" and a badger 20 moa rail on a 700 s/a. Many others were no so lucky. I strongly suggest you go with 1" if they have not already shipped.

 

[Triad]

If you need them, we have the Badger 1" in stock:

https://www.triadtactical.com/Badger-Rings-306-14-34mm-1.0.html

 

[Rob01]

Seekins .92" height works fine with my S&B 3-20. 1" isn't that much higher so go that way if you want to be sure. I use the 1" on my 5-25x.

 

[wegner426]

Look at American Rifle company, I want to say they are something like .94 if I remember correctly.

 

[jonthomps]

If you need them, we have the Badger 1" in stock:

https://www.triadtactical.com/Badger-Rings-306-14-34mm-1.0.html

Thanks. I was messing around on your site this morning and bought a stock pack!

 

[scudzuki]

Just grind some clearance on the top of the barrel with a disk grinder if the rings are not high enough.

Joe

 

[Rob01]

Just grind some clearance on the top of the barrel with a disk grinder if the rings are not high enough.

Joe

That's funny as I saw a guy do this to a GAP rifle at my range. I didn't say anything but was seriously cringing inside. Had a Leupold scope and their cheap twist in rings on it.

 

[scudzuki]

That's funny as I saw a guy do this to a GAP rifle at my range. I didn't say anything but was seriously cringing inside. Had a Leupold scope and their cheap twist in rings on it.

Well at least you knew I was joking.

Joe

 

[phxfa]

you can relieve the center of the rail a bit once you figure out your eye relief. wouldnt do it on a integrated receiver/rail setup

 

[Captain Kirk]

As Rob mentioned, you cant get much lower than Seekins 34mm rings