- Thread starter wch
- Start date
I use 45.5 grs of Varget, Winchester brass, CCI BR primers , 175 MK in my .300/.308 barrel with 95 Palma chamber seated into the rifling
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
44.2 varget. Cci br2 primer, Lapua brass (fire formed as new isn't as accurate) .336 neck, 2.173 ogive. I think it's a 2.878oal?
I also have had great luck with federal brass. Same load.
Note: the new lapua shows slight pressure signs with 175smk. I fire form with the same powder charge but a lighter bullet. Then no problems after that.
I also have had great luck with federal brass. Same load.
Note: the new lapua shows slight pressure signs with 175smk. I fire form with the same powder charge but a lighter bullet. Then no problems after that.
Sleuthing the Federal Gold Medal Match long range load recipe. - YouTube
if that don't pop up type in sleuthing the federal gold medal match
if that don't pop up type in sleuthing the federal gold medal match
44.0 grains of Varget, 210M primer, Winchester brass, seated so that it is just touching the lands in my Savage. Usually good for .5 moa or less at 100 yards if I'm doing my part.
Last edited:
I think it depends on the rifle. What works great in my 10BA does not shoot well in my 12 F/TR. You can read some good starting points in the stickys but you have to find one that works well for your rifle.
Above are good places to start.
Above are good places to start.
44.7 Varget, FGMM primer and Lapua brass.
It has shot very accurately in all but one of my many 308 rifles.
It has shot very accurately in all but one of my many 308 rifles.
What velocity are you getting? What barrel length?
I am at 43.5, so OCW says the next higher node would be at 44.8
