Just wondering if anyone had any first hand experience with either of these two rings? I finally convinced my wife to let me buy a NXS 5.5-22X56 (only took 5 years!)and need new rings. Which ones would you get? I don't have the scope here yet, but was told 1" high rings will be ideal. Is this true? Scope is going on a Remington 700P in a AICS. Thanks all.
Rifle Scopes Barret Zero-gap rings or Badger USMC Rings DMR rings?
- Thread starter 700P
- Start date
Badger would be what I would use, hands down...
Badger or Nightforce rings I do not see you needing the Max 50.
Mike @ CSTACTICAL
Mike @ CSTACTICAL
I would go with Barrett Zero Gap rings, but may be overkill! They do work well. Would also recommend an Accuracy First level, if you're going to do it right the first time!
I use Badgers mostly, and Leupold.
No experience with the Barret rings.
No experience with the Barret rings.
1" height should work fine with the 56mm objective. I use it on my S&Bs with 56mm objectives.
As to type, I would take the Badger over the Barrett having owned both. That said, have you looked at Seekins Precision?
As to type, I would take the Badger over the Barrett having owned both. That said, have you looked at Seekins Precision?
OK thanks all. I just did some measuring and think I may have to go higher than 1" with the rings according to the scope ring hight sticky on the top of the page here.
Similar threads
