• Winner! Quick Shot Challenge: What’s the dumbest shooting myth you’ve heard?

    View thread

Recent content by 10 Gauge

  1. 10 Gauge

    Suppressors Heavy suppressors & barrel droop? Or is it something else?

    Great advice, thank you! I didn't think about rotating the detent ring. I still haven't had a chance to go and look at my rifle, been busy. Hopefully next weekend I can give this a test.
  2. 10 Gauge

    Suppressors Heavy suppressors & barrel droop? Or is it something else?

    I haven't tested if it's landing between notches yet, but if it is, should I back it off so that it sits in the detent prior to full lockup, or is there something I can do to get it to snug to the next notch?
  3. 10 Gauge

    Suppressors Heavy suppressors & barrel droop? Or is it something else?

    Interesting, thank you, I did not know this. I need to find a new can for this rifle.
  4. 10 Gauge

    Suppressors Heavy suppressors & barrel droop? Or is it something else?

    Zak, isn't that typically for the overall shift? My problem seems more complex than this, as I get my regular POI shift from suppressor on vs. off, then I get the shift described in the OP as well.
  5. 10 Gauge

    Suppressors Heavy suppressors & barrel droop? Or is it something else?

    I'm fighting an issue I just can't seem to put my finger on for a solution, hoping someone on the hide may have some input. A few years ago I got a ridiculous deal on a YHM Phantom M2 .30cal QD stainless suppressor, it was too good of a deal to pass up. My idea was to use this suppressor on my...
  6. 10 Gauge

    Rifle Scopes Bushnell XRS QC Issues?

    Thank you so much!
  7. 10 Gauge

    Rifle Scopes Bushnell XRS QC Issues?

    If the scope hasn't left your shop yet, any chance I can throw you like an extra $20 to bump that ground up to like 3 day select?
  8. 10 Gauge

    Rifle Scopes Bushnell XRS QC Issues?

    CSTactical Well I would have to say you are right about that. I feel I definitely need to follow up on this thread here as well. Steve Hanna at Bushnell personally called me about 15-20 minutes ago after hearing about my story. They were more than accommodating and apologetic for the problems...
  9. 10 Gauge

    Rifle Scopes Bushnell XRS QC Issues?

    I am just going to repost my post from Facebook on a long range group I'm in.... TLDR version = Bushnell is complete garbage, never again. I feel like I need to share a horrible experience I've recently had with Bushnell. I bought an XRS 4.5-30 scope (~$2k) new from Midway. I get the scope...
  10. 10 Gauge

    Rifle Scopes Bushnell XRS QC Issues?

    Repaired or replaced scope is scheduled for delivery today! Pretty quick turn around, I can't complain, just hope it's GTG to this time.
  11. 10 Gauge

    Rifle Scopes Bushnell XRS QC Issues?

    I definitely wasn't trying to insinuate that they have a QC issue, I was merely inquiring as to if they did have a known QC issue. It seems to be a resounding "no" that they do not, which is exactly what I was hoping to hear, and am relieved. It is a 34mm model as well. I have yet to hear...
  12. 10 Gauge

    Rifle Scopes Bushnell XRS QC Issues?

    Everything sounds promising, thanks for the reassurance. My scope showed up to their lab repair department yesterday. Do they inform you at all of the status or receipt of your item, or you just randomly receive something in return at some point down the road?
  13. 10 Gauge

    Rifle Scopes Bushnell XRS QC Issues?

    Thank you for the feedback. I needed that reassurance that this wasn't a common failure area for this scope. Thank you also for the tip on the setting the zero stops, I will definitely look that up when it comes back. Also glad to get extra confirmation that the glass is better than the...
  14. 10 Gauge

    Rifle Scopes Bushnell XRS QC Issues?

    Hello, brand new forum member here with my first post. I recently acquired a 6.5CM RPR and decided to pick up two scopes to compare, the Burris XTR II 5-25 and Bushnell XRS 4.5-30. After spending a day looking through both scopes side by side and jogging through the turrets, etc, I decided to...