Latest activity Postings Featured content About Feedback Stats
-
-
For that spot in front of the front action screw, you can take a look at the underside of the action and get an idea of how much you... -
The only tricky part is right in front of the action. The barrel sits below the action flat and you need to be careful to preserve the...
-
That’s really nice. I didn’t think those would fit the MTR stock without removing a lot of wood. I think I’m going to have to get me...
-
Shot this target this morning with my new to me 457 Lilja Manners. ARA unlimited target.
-
p5200 replied to the thread L3i barrel o Lilja CZ 457 questions.Nice! (y)
-
It’s not much work to fit the l3i in a stock if you’re handy with sandpaper and a 30mm pipe. It’s really all about balance, if you’re...
-
The L3i will require modification of stocks. The lilja will fit it almost all CZ standard barrel channels. I’ve only shoot match ammo...
-
I've been looking around at aftermarket barrels. Trying to decide between L3i and the Lilja barrels. I won't be shooting match grade...
-
Run your finger across the Serial number on bottom of bolt. Remove it and careful to not damage any other area, run a fine tooth file...
-
Isn't 4/3rds past the muzzle?
-
tl;dr: Unless there's some additional reason to go with the T1X, aftermarket support for CZ is better. ------ From what I've seen at the...
-
p5200 reacted to ST42's post in the thread Unlike Honey Bees, Hornets sting, and sting, and sting…. with
Like.
I just had to post up about my New TACOPS Green Hornet. Mike built this hammer for me over the past 6 months. I am just now getting the... -
No, the shims that came with it are 0.002, 0.004, & 0.006
-
Just got my barrel in this weekend and it’s a shooter! Extremely pleased with the results, here’s 3, 10 shot groups at 50 yards with...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
