Recent content by 260aics

Re: What to use instead of torque wrench? <div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Pointblank4445</div><div class="ubbcode-body">If there are torque specs for something there is probably a reason. So, get off your lazy ass and go and buy or borrow a...

Re: What to use instead of torque wrench? Vermonter please excuse the dumb asses on here that think they know everything, must be a bunch of dump ass cops. I would buy a cheap torque wrench from harbor freight. All your going to do is tighten some screws on a gun or scope. It would be...

Re: .223 AICS Mags I'm thinking of switching to the AICS for my .223 and wanted to see if it would take the longer bullets. Do you have any AICS in stock? I checked your website but it seems to be down right now.

What is the COAL that can be loaded in them?

Re: Stainless Steel Media Testimonials I just bought some new dies and I was thinking of tumbling them with the ss media to clean out the oil and grease thats shipped on them. Just the body of them. What do you think?

Re: 69gr Sierra MatchKing A loaded round with the 69gr SMK that would be touching the lands in the rifle is 2.281 max OAL. The shortest that I can load that round would be 2.269, after that the ogive of the bullet will be inside of the case mouth. I feel like the reamer needs to be run...

Re: Need a new scale. I've got the 502 and have no complaints about accuracy. It is however, slow.

I am reloading for a Remington 700 in .223Rem caliber. I had a smith put on a 1 in 8 twist barrel to shoot the heavier bullets. When I measure the distance to the lands in the chamber I get 1.772 off the ogive of the 69gr Sierra Matchking. The max case length for the .223 is 1.760 by the...

Re: 5 calibers everyone should own .223 Rem for semi rifle, easy to find ammo .260 Rem does same thing .308 except better .338 Lapua for long conversations 12ga everybody bird hunts right? .45 acp enough said maybe a .22lr for the kids

Re: Stainless Steel Media Testimonials Spoke to them today. They said that they were going to start putting the star washers on. He wants to send me a few different shafts to tryout, then call him back and let him know what I think.

Re: H4350 a good choice for 260 AR-10? I shoot H4350 in my .260 bolt gun. Easy powder to work with. Shooting 140 A-max's.

Re: Stainless Steel Media Testimonials I sent a check to Mark on Thursday and the media was at my door today when I got home. Cant say enough about this guy. Anyway, I started the new tumbler up with the media and some .45 cases. Couldn't wait so I checked it after only 30 minutes. Wow...

Re: 50gr V-Max Jump The speer manual says max of 27.5, but I'll go up a little more. You dont think setting it back maybe .025 would help? I might have to try another powder, which one would you recommend?

Re: 50gr V-Max Jump Yes its .223 Rem. No mag just floor plate. I'm using BLC-2 started at 25.5grs and went up by .3 to 27.3. 26.7grs seem to shoot the best, but not what I'm looking for. I wanted to start playing with the jump. I would like to use the BLC-2 because I have 4lbs that I...

Re: 50gr V-Max Jump It's a Remington 700 bolt gun. I've been setting it back .005 and not getting the groups I want. Any ideas would be great.