Recent content by 260shooter

All parts acquired. Waiting on a reamer.

I'll take the TAB Gear pinnacle sling

Frank do you happen to know if the bullets were made with powdered tungsten. I had heard that probably 20 or more years ago. Innovative in that the bullet wouldn't leave the body of the bad guy, which could come in handy when shooting into crowds. I also heard those that this type of bullet...

I'll take the GEN 3 APA LB

Good snag

Have you tested different seating depths?

Trying to figure starting loads for a 147 gr bullet. Would using a 7 PRC and a 175 gr bullet from Hodgens website be a good starting point?

The history channel did a show on LEO/military snipers in the early to mid 90's and had a segment on the SS snipers. A guy they interviewed mentioned the JAR. As I remember it was a 700 action bare stainless barrel and a black A-3 stock.

I'll take this per PM.

I had an old open can of a IMR (don't remember) and upon opening it there was rust on the sides of the can. It went in the trash.

I'll Take all three per PM.

Thank you very much. Will have a mag length of 3.600 to play with, so I should be good with the heavies. Dies are next on the list, a long list.

Thanks Terry for the knowledge bomb about chambering multiple barrels and reducing load work up an subsequent barrels. As for suppressor use, I'm in Illinois for now. When I get moved I will be acquiring a few suppressors. By the way, the 300 PRC I bought from you is a great shooter. Settled...

(y)

Different charge weights won't matter. All will have more than enough pressure to fireform the case. I would set my neck tension on virgin brass. Make a dummy round and measure the neck, minus .002-.003 for your bushing size. Use a expander mandrel on virgin brass then run them through your...