Recent content by 58blackflag

Looks like the mag release is on the right hand side so it can be engaged with left thumb. Very cool pistol indeed!

I have the mil XT reticle in mine. The main cross hatches are illuminated but not the “tree” marks below the horizontal. I find even the lowest setting of illumination too bright for low light hunting at dusk/dawn but that has been the case for me with every illuminated scope I’ve ever had. i...

PM’d you

I’ll take the railchanger and bags. Please PM me PP info and I’ll send payment tomorrow.

For 5.56 ammo I recently tested the following: 18” Seekins .223 Wylde with TBAC 30P-1 suppressor. Speeds are taken from 10rd strings except last group, see below. IMI 77gr Avg 2726 ES 31.4  AAC 77gr non-Sierra Avg 2635 Es 21.8  Black Hills 77gr OTM Avg 2682 ES 17.1  Black Hills 77 TMK...

Try https://www.altusshooting.com/

I usually set my zero stop about 0.5 mils under 0. I have my gun zero’d with a suppressor, so if I take it off, I usually need a bit of room to come down to zero with the can off. On my NF it’s way easier to leave a little room under 0 just in case rather than have to remove the turret and...

I'll take it per our PMs.

PMd an offer as well.

They sure did back in the day. Around 2016 there was a full RRS tripod setup on just about every prize table. They also donated setups to be used for RO spotting and for tripod specific stages where all the competitors would use the donated setup in the COF. I would say that is a big part of...

I'll take it!

Cheers, thanks fellas!

I'm looking for recommendations for a binocular ARCA mount that is fairly low profile. I have the Sig Kilo6 LRF Binos and a Leofoto MA30-L head. I bought a cheap mount that just has a stud on the bottom requiring the need for a separate ARCA plate adapter. If anyone knows of a single piece...

https://www.sunrisetacticalgear.com/Arm-Board-G2-3500618.htm I like this one. I print out full dope cards to go inside and use the front for senario-specific data using a dry erase marker.

I’m not sure what height exactly. They measure around .95” from top of rail to the split. They should be right for a 50-56mm objective scope on a bolt gun but too low for a flat-top setup.