Recent content by axarob44

I would not deal with Pacific Tool and Gauge. Search the name, you'll see.

I have a like new SAC 7PRC Modular Sizing Die setup for sale. I'm going to be honest here, I have problems with this die sticking brass. I'm feed up with it and I'm done with it. My loss is your gain if you feel like giving it a try. I've probably sized about 50 cases successfully. It comes...

Okay I'll ask. Thank you! ETA: Contacted Craddock and he said he would do it. Thanks _Windrider_ !

Any one know of a place where I can get my barrel milled for a older setscrew front sight gas block install. ADCO says they no longer do it, PRI said they won't do it on someone else's barrel which is BS in my opinion, what ever. This is a HCS Mk12 barrel. Any help would be appreciated!

How did it come out? Look good?

I was able to talk to ARC today. They are sending out two new pads. I hope it was a bad batch or something like that. Is it possible to sand another standard butt pad down that far to fit on that narrow plate? Isn't there some type of internal "frame" that is molded over with the rubber if you...

I thought I saw in an earlier thread when they first came out people were bitching about them being to narrow and HARD so maybe they went with a softer compound. I'll see if I can find it again. I don't know, I'm at a loss. I can't baby them anymore than I already am and there is no other option...

I can't be the only one with chunking and cracking butt pads on this chassis. My new butt pads are both split and one has a big chunk out of the side. These things are to narrow to be this soft. If you have a Xylo chassis take a look at the buttpad to see if any of yours are spit, chunked or...

I have two surplus Colt AF forge marked stripped upper receivers for sale. These are pretty well worn receivers that I was going to use for clone builds, but decided to use new instead of these. They light acceptance stamps in the front of the port door also. $120 each shipped or $225 shipped...

Sold

I have a used and painted Leupold 60025 (2010 prodution date) LR/T 3.5-10x40 TMR reticle NON-Illum. M3 turrets (1MOA) (.5MOA Windage). I have a 168gr .308, and a 55gr .223 turret. I had a turret made for IMI Razor Core out of my MK12 Mod0. See picture of custom turret. It has ring marks under...

Unknown Munitions has Peterson brass 7PRC in stock. Just a heads up.

Those dies have seen some use lol! I will post back when I get the die and I always get a couple mandrels too so I can polish them or modify the diameter. I think it makes me so mad about these things because they can be a great tool for the reloading bench. Very versatile. You would have...

I might have to look into the 30-06 idea. They're cheap enough to give it a try.

I'll try it with a slotted washer, see if it's a pain to fumble with, maybe won't be too bad. Maybe I'll make a special shell holder.