-
Having trouble using the site?
Contact support
Recent content by Bestboss
-
B
Just picked up Rem 721 300 H&H Mag
Re: Just picked up Rem 721 300 H&H Mag Must have been in a bad mood to cut down that fine rifle. Either way, magnums do not have to always be magnums. I shoot a lot of the big boys and find a bit less powder and some experimentation, will give me some awsome combinations. The 300 H7H is a...- Bestboss
- Post #25
- Forum: Vintage Sniper Rifles
-
B
Suppressors In the market...
Re: In the market... I have a 38 Super, Combat Commander (Colt)which by most standards is a very nice example of the 1911 series. I spend more time oiling it than shooting it. At the opposite end of the extreme, I have a full size Springfield with the matte finish, standard 3 dot sights...- Bestboss
- Post #6
- Forum: The Armory
-
B
Suppressors question for the revolver crowd
Re: question for the revolver crowd My 1992 Hercules reloading guide shows 7 grains as the maximum for Green Dot with a 158gr JSP in 357. The date for some of the flake powders can be elusive at times. Your reference to keyholing, I suspect may be mis-read, at least by me. I define...- Bestboss
- Post #9
- Forum: The Armory
-
B
Bought used Armalilte AR-10 and need info
Re: Bought used Armalilte AR-10 and need info I found two quarters in the back of the buffer tube assembly. Are they there to protect that area from a beating, or to strengthen the spring a bit? Larry- Bestboss
- Post #9
- Forum: Semi-Automatic Rifles
-
B
Suppressors 357/38 ammo
Re: 357/38 ammo I will offer my experiences with an S&W 342 PD. It is the 10.4oz 38. Possibly the lightest one they made to date. It recommends right on the barrel, jacketed bullets only, as the cast bullets can come unseated during recoil of the light revolver and jam up the cylinder...- Bestboss
- Post #4
- Forum: The Armory
-
B
Bought used Armalilte AR-10 and need info
Re: Bought used Armalilte AR-10 and need info I spent some time going through the rifle this evening and can find a couple things I want to address. The barrel hinge pin does not lock up in the closed position - easy enough fix. The forearm retainer ring does not slide onto the back of the...- Bestboss
- Post #8
- Forum: Semi-Automatic Rifles
-
B
Bought used Armalilte AR-10 and need info
Re: Bought used Armalilte AR-10 and need info Well, I talked to Armalite today and it turns out that this rifle was shipped as a stripped reciever in 2009. For better or worse, I have bought me a project. The gal at the factory, said just go out and shoot it and I will, but I want to know...- Bestboss
- Post #6
- Forum: Semi-Automatic Rifles
-
B
Bought used Armalilte AR-10 and need info
Re: Bought used Armalilte AR-10 and need info Hello ORD, The model designation is simply AR-10. It looks a lot like my Colt HBAR on steroids. Same 2 piece forearm, but flat top. I think A-2 style would apply. Not a free floated rigid tube. The barrel is not stainless, so does chrome-moly...- Bestboss
- Post #3
- Forum: Semi-Automatic Rifles
-
B
Bought used Armalilte AR-10 and need info
Morning all, Nice board you have here.... After 40 years of guns and dealing and have AR-15's, but I never owned an AR-10. This weekend, I picked up a used Armalite with the following features: Cal 308 20" barrel Standard stock, with round forearm Flattop Serial # US 326XXX One notable item...- Bestboss
- Thread
- Replies: 14
- Forum: Semi-Automatic Rifles
