Recent content by BIRDHUNTER

Here is my 2022 6x5. Best group.149 CTC best group MOA .285 avg. CTC .3256 MOA AVG. .6218 RimX, Green mountain barrel 1:16 Harrell tuner SK LongRange

Yes it will shoot it. That being said I suppose the chamber you choose to run will have something to do with function and accuracy..mine is a Lilja 2 chamber. Greenmountain barrel 24”, just crowned. Here are some groups with inexpensive ammo at 50 yards..

Here ya go.

Mine shoots it pretty good.

Thought I would post this since match ammo is tough to get And I found it interesting. Pretty good for inexpensive ammo. Prone, Ckye pod, W/Rear bag, 50 yards RimX Green mountain barrel, 24” crowned Manners T2A Vortex AMG Agulia Super Extra HV 40gr

Prone, Ckye pod, W/Rear bag, 50 yards RimX Green mountain barrel, 24” crowned Manners T2A Vortex AMG Lapua center-X

Terrapin dose not have an internal target card function, however if you are using the kestrel you can create a target while using a connected kestrel. It must be done manually in the kestrel. Laser target A then B etc. then scroll down to the target card in the kestrel and it will all be listed...

That will work. Should get some good data.

You already got the .001 data, load up some with the .289 bushing and compare. If that was the first time shooting that brass the second round might print a little differently now that the brass is fireformed to your chamber. Don’t forget to measure a couple of pieces of brass after resizing for...

Where I would look is between 41.5 and 42.4. Load them up in .1 increments. Ex. 41,5, 41.6, 41.7 and so on. Scott Satterlee has a good video on how to use this method. Might have been a 6.5 Guys interview? In short, look at your speeds, you should find a flat spot among 3 speeds or so. Choose...

What powder

Sinclair is cut with a 1’30” taper just like most chambers. Hornady does not. That’s why there is a difference in measurement. Sinclair will give you a better comparison if you are working off a reamer print. Is it perfect no, is it a more accurate measurement of the olive, yep.

You have a hotter lot of powder. From a base line, lot to lot burn rate can be plus or minus 5%. What is your speed with 41.5grs?

No, pressure is good.

Not much info out there so I thought I would start one 284 Shehane 26” krieger 1:8 Bighorn TL-3 Long Action 6.5/284 Lapua necked up and donut reamed out 56.8gr 4831sc CCI LG primer Reamer specs - 235 FB, 317 neck 184 Berger Hybrid OAL 3.262 Loaded round, 312.5 neck, 310 neck bushing 2825fps