Recent content by BJKrauel
-
B
Gunsmithing Objective research on Barrel Break-in procedures
Re: Objective research on Barrel Break-in procedures I enjoyed reading this thread, although it took me a very long time. I have been wondering about a "break-in process" along with different methods of cleaning. I have noticed that if I clean the bore completely of copper and fouling my...- BJKrauel
- Post #110
- Forum: The Armory
-
B
Gunsmithing Remington 700 .308 bore cleaning method
Re: Remington 700 .308 bore cleaning method Thanks handym3000, I have just been reading the hot thread for barrel break-in procedures. Lot of interesting opinions on there and some good data. I always use a dewey cleaning rod with jag, pro shot bore guide, cotton patches and butches bore...- BJKrauel
- Post #3
- Forum: The Armory
-
B
Gunsmithing Barrel Length for .30-06 1000 yd shooting
Re: Barrel Length for .30-06 1000 yd shooting That is correct, Barrel length is from bolt face to muzzle per ATF. Not all people measure it that way but its the best to use if checking legal length. Then if you want to check length of actual rifling you can subtract the OAL of the...- BJKrauel
- Post #17
- Forum: The Armory
-
B
Gunsmithing Remington 700 .308 bore cleaning method
Sorry Guys, I am new to this site and am sure this has been a worn out subject....But I need some opinions on cleaning methods. I have been an LEO sniper for 3 years and used to always use the chemical cleaning method only. Now that I have a new Lilja barrel I am finding my method of cleaning...- BJKrauel
- Thread
- Replies: 9
- Forum: The Armory
