Recent content by BlisterSix
- B
Lapua 144 FMJ in 6.5 creedmoor?
While building up my 6.5, I've been searching around for components to reload for it once it's running... Stumbled across the lapua 144 FMJ with a BC of .636. Anyone have any experience with these bullets? It's one of those things that sounds way too good to be true...- BlisterSix
- Thread
- Replies: 1
- Forum: Reloading Depot
- B
RL-17 (Alliant) for 6.5 Creedmoor
Anyone know where to get either RL-17 or H4350? Im just getting into the 6.5 Creedmoor and can't seem to find either of these powders anywhere. I've got 10 lbs of Varget and 16 lbs of 8208 XBR, but nothing suitable for the 140 amax in 6.5CM.- BlisterSix
- Post #40
- Forum: Reloading Depot
- B
AICS mag feed with issues pointing ammo into chamber.... 6.5 creedmoor HELP????
I'm building a 6.5 Creedmoor on an XLR chassis... hope I dont run into the same problem...- BlisterSix
- Post #3
- Forum: Bolt Action Rifles
- B
yall going to get a kick out of this one... you cant make this stuff up i swear
Im sure someone will still buy it and tell all their buddies about their new "Sniper Rifle."- BlisterSix
- Post #30
- Forum: Bolt Action Rifles
- B
New Member from Eastern PA
Hello all from the Hide! I've been a "lurker" on the site for some time, but have finally decided I should join and contribute. I've been shooting for about 10 years and I'm a NRA Certified instructor. I just recently started a build of a precision 6.5 Creedmoor and figured it was a good...- BlisterSix
- Thread
- Replies: 1
- Forum: New Member Introduction