Recent content by BOL556

Update: Went out today and tried a little of everything, different spring carbine buffer, ensured the gas block had not moved and the hole in the barrel wasnt blocked. All test were conducted with hornady 55gr 5.56 factory loads. Didnt matter what I tried above the bolt still would not cycle...

Has nothing to do with the buffer system I have ran this AR with the T2 and mid length gas for over 2 years. Also my buffer is filled with tungston powder not weight like shown above. Most likely what I said in the original post it may just be the gas tube is fouled and either has to be...

Hello all, Having problems finding a load that will cycle the action when my suppressor is off. I have tried every load possible. I try the hand loads with out the suppressor and it acts like I am shooting sub sonic loads. If I put the suppressor on using the 10% load start out all the way...

Hello everyone Recently started building a LR308 and looking around and seen that some rifles were running full rifle length gas systems with the carbine buffer. I was always under the impression that you would only use carbine or mid length on a carbine buffer system. Please educate me on...

Just sent an email.

175 SMK from Southwest. Orginally I was shooting the 168 SMK because that is what FN recommends for my A3G. However, the more I shot and further I went out I noticed the 168 SMK after 800 yards was being shifted all over the place by the wind.

Battle sight zero the sight meaning front post flush and rear centered. Start at 25 and move back from there. Sounds like you are doing the right thing, does the sights say anything about zeroing using the sights with the 200-600. I normally zero using a M4 zeroing target and I am good out to...

Would love to have the stock. What mount are you using for the optic. Recently received my Vortex 4-16x50 to mount on mine but not sure what mount to go with. Hopefully by the end of the summer I should have the rail extension so mine will be pretty close to what is depicted.

Re: SCAR17 and SCAR16 side by side Sweet I have twins too.

Re: new romanian M10 AKs I have this one with a vortex sparc red dot and I was highly impressed with the groups that I got. I hope this is one that you were talking about. http://www.centuryarms.com/visualnet/Consumer/July2012Consumer/#/1/zoomed

Re: Who do you think is making these barrels. Daniel defense and FN barrels are what he is describing. Palmetto state armory is using FN barrels as well. If you go to any of their websites you will find the info you are seeking. Either way you go its not going to matter cause they are made...

Re: Help - Rifle Identification and Information http://www.jprifles.com/1.2.1_PSC_12.php

Re: SCAR 17 front sight tool This is what I use. http://www.tapco.com/products/ar/index.php?_a=viewProd&productId=111

Re: What yard zero are you guy's using 100,200, or 300 Red dot 25 yards=300 yards, scope 100 yards with come up either using my shooter app on my phone or just by memory.

Re: Shooting an AR from the ground on side poi shift? Your wind and elevation switch when the above shooting position. Your wind becomes your elevation and your elevation becomes your wind adjustment. There is also some guys that responded to my very same question. Hope this helps...