Recent content by BrassWhole
-
G1 as a factor for bullet/round selection
Based off what I've read, it's more likely with your boxed factory ammo that CBTO is one of the main differences causing an influence in what you believe shoots better from your rifle. Measure the CBTO of factory ammo, they are all over the place. I've seen bullet jump in excess of .1" with...- BrassWhole
- Post #11
- Forum: Reloading Depot
-
Homemade Induction Annealer
I could use a little word of encouragement. First off, I don't see how at this point in my build this would work. Looks like a direct short waiting to happen. I am trying to build this as a stand alone unit that will mount on top my Dillon XL650. It looks pretty, but in not convinced it will...- BrassWhole
- Post #778
- Forum: Reloading Depot
-
Homemade Induction Annealer
Electrically not connected yet, have the basic machine sitting in top on my Dillon XL650. Some items sourced used, or open box from e-bay. I have a buddy that's going to help me get the plug wired for the power supply, currently at a stopping point until after July 4th. The plan is to...- BrassWhole
- Post #753
- Forum: Reloading Depot
-
Homemade Induction Annealer
I'll be starting my project soon. Planning to mount the coil onto a tool head for a Dillon XL650. Photo is not mine, but of course from YouTube. Looks like a hair pulling project, you all have been a lot of help. This was a very good read, and no i havnet even tried to read all 15 pages of this...- BrassWhole
- Post #734
- Forum: Reloading Depot
-
Shoulder bumping .308 cases
I realize this is an old post. I've had to remove material off of more than one F.L. resizing die over the years. Here's what I do, take die apart, and measure the body overall length. Get out the old diamond stone and hold perpendicular run it in the stone a while, rotating 90° every few passes...- BrassWhole
- Post #24
- Forum: Reloading Depot
-
375 Raptor load data
I personally love the cartridge! However I load for my 10.5" AR-10 so I rarely load supersonic ammo. Looking back I think load development would have been easier with a 12.5 or something close to that. The short barrel, with the combination of getting the AR-10 to cycle has been challenging at...- BrassWhole
- Post #3
- Forum: Reloading Depot
