Recent content by bubbala
-
B
Checking in from SoCal
You might try calguns forum. Not too much in long range,but it's in state.- bubbala
- Post #4
- Forum: New Member Introduction
-
B
AGS case annealer?
I've never needed a 2nd torch on my bench source,but my largest case is 300 win mag.- bubbala
- Post #6
- Forum: Reloading Depot
-
B
17 hornet.
has anyone had any luck reloading it? details please. powder,primer ,bullet?T.I.A.- bubbala
- Thread
- Replies: 15
- Forum: Reloading Depot
-
B
300 Win Mag advice
don't overlook cz.my 550 in 300 win mag is a great shooter,but I reload.lot's of info on Cz forums- bubbala
- Post #30
- Forum: Bolt Action Rifles
-
B
Crappy groups AFTER annealing
The Art and Science of Annealing- bubbala
- Post #7
- Forum: Reloading Depot
-
B
Did I over anneal my brass? help!
The Art and Science of Annealing- bubbala
- Post #22
- Forum: Reloading Depot
-
B
How do you make a CZ 455 better?
try Rimfire Central you might get some advise,tips over there- bubbala
- Post #5
- Forum: All Things Rimfire
-
B
Sig 522 Rifle - Who has one?
hey komishe, post a link or some info on that trigger fix. like to lighten mine up. tia.:cool:- bubbala
- Post #8
- Forum: All Things Rimfire
-
B
Opinion on this annealer
the cases look to be turning, but barely any time in the flame. and they're dropping in to a plastic bowl. how hot could they be. not 750.- bubbala
- Post #6
- Forum: Reloading Depot
-
B
CZ 455 Switch Barrel Questions
do not believe cz makes a 17 HM2 barrel though. other barrel makers might.- bubbala
- Post #4
- Forum: All Things Rimfire
-
B
Sig Sauer SSG 3000 full write up and myths clarified.
i did have to drill out the grub screw on mine. it was too small and tight to get out without buggering up the (socket ?) anyway the barrel has a recess drilled in it where the screw is so if you have to drill ,don't be concerned about ruining the threads. was going to drill and tap the brake...- bubbala
- Post #119
- Forum: Bolt Action Rifles
