Cold_Bore_88's latest activity

Consider doing sizing on a Dillon. I have a 550B. In the past, I set up a toolhead with a full length 308 button die and a mandrel. I...

Thanks, hmm makes me wonder if I should wait to pick it up or not. I need to get 6.5CM dies too so might just start with those.

8-12 weeks before available. I ended up snagging the last click adjust die Whidden had.

I have often considered this but never dove in. I may look end up going this route. Do you find the distance to the lands correlates...

I am leaning towards Whidden. Their expander ball/mandrel seems like a good design that most have success with. I may just get their...

I’ve had both hornady and Redding that work like crap and some that work splendidly. Forster also used to be my default recommendation...

Edit: nvm. I am an idiot.

I actually emailed Mark Gordon this morning to see if they did a 300 PRC. I couldn’t easily find one on the website.

Hornedy match sizer. Well designed decapping rod and expander ball. Very good internal finish, properly dimensioned, and priced right...

Gents, I am a very lazy reloader. I want it done right and quick. I don’t worry about cost. I want to “cam” as few times as possible...

I've killed loads of hogs with the 62 grain gold dot out of my 11.5". They're my go to, with the 70 grain tsx being a close second.

You are the man!

6mm ARC Hornady 108's out of a new 14.5" Proof CF barrel. Velocities usually pick up another 20fps as the barrel gets some rounds...

Just edited- I got tell you there's a big upgrade IMO when I added the A5 and LMT enhanced BCG. Really smoothed out the recoil impulse...

If I could ever find an LMT E-BCG I would buy it. I am on every “in-stock” alert I know of. They either sellout in minutes or people...