Recent content by davidlbeaty
-
D
Ammo question
Re: Ammo question Obviously the 168s as is any 308 round at their outer limit at 1400 yards. The course was in Phoenix at about 1200 feet. The temperature was about 80 and it took 74 minutes of elevation to get there. In the spotting scope you could watch the con trail on the bullet and the...- davidlbeaty
- Post #16
- Forum: The Armory
-
D
Ammo question
Re: Ammo question I took a 50 hour sniper course in October and used 168 Prvi match ammo. It worked very well in my Remington 700. I had setback the barrell so the bullet was close to the lands and at 100 yards shot 3/8" groups. We shot steel out to 1400 yards with a little less than a full...- davidlbeaty
- Post #5
- Forum: The Armory
-
D
Grinding a FL sizing die?
Re: Grinding a FL sizing die? A full lenth sizer die is designed to bump shoulders a limited amount. If a reloader is not paying attention they can increase the headspace too much, so the manufacturers only build a limited amount of bump into a die. Usually when brass is getting difficult to...- davidlbeaty
- Post #13
- Forum: Reloading Depot
