Dolomite's latest activity

  • D
    Dolomite reacted to Edsel's post in the thread Annealing issue with Like Like.
    https://www.snipershide.com/shooting/threads/giraud-annealing-machine-modifications.222311/ Pressure Gauge modifications you might be...
  • D
    Dolomite reacted to Grizzgup's post in the thread Annealing issue with Like Like.
    I did not know the tank needed to be below the burner. I appreciate that advice! I will try that!!
  • D
    Dolomite reacted to Holliday's post in the thread Annealing issue with Like Like.
    I run mine on the table alongside the Ugly and never had an issue. It is sitting upright.
  • D
    Dolomite reacted to Edsel's post in the thread Annealing issue with Like Like.
    It's liquefied gas - I suppose this is analogous to "flooding the engine."
  • D
    Dolomite replied to the thread Annealing issue.
    Curious as to why the tanks need to be below the burner? I have mine on the side of the burner on the table standing straight up.
  • D
    Dolomite replied to the thread 2 heavy bolt lifts and dirty cases.
    try reshooting those cases, maybe it’s just isolated to those pieces of brass or shoot that load again. I never had luck with Starline...
  • D
    Dolomite reacted to stello1001's post in the thread 2 heavy bolt lifts and dirty cases with Haha Haha.
    I shoot under a pink tent hahaha. I thought so too, I figured on low charge cases where the brass does not fully expand to seal the...
  • D
    Dolomite replied to the thread 2 heavy bolt lifts and dirty cases.
    It normally happens on lower charges. I do love the exotic lighting on the pictures.
  • D
    Dolomite reacted to 4O6shootist's post in the thread 6mm BR with Like Like.
    109 Berger, Viht N150, jumping 60k, L group is 30.5 going 2860, R group is 30.0 going 2815. Both 10 shot group. UPS man dropped barrel...
  • D
    Dolomite reacted to Niles Coyote's post in the thread 6mm BR with Like Like.
    Berger 108EH jumped 55-60 thou and Varget... 30.0 grains look good considering I watched the reticle on shot #4 drop low left just as...
  • D
    Dolomite reacted to dubbednate's post in the thread 6mm BR with Like Like.
    Sounds like a plan. Yes. I use a Burstfire Annealer.
  • D
    Dolomite reacted to Roadrace33's post in the thread 6mm BR with Like Like.
    I finally jumped on the BR wagon and ordered a prefit for the ATXC. 105 hybrids and 29.5 GR varget. New lapua brass and a cci br4 puts...
  • D
    Dolomite replied to the thread Terminus Actions.
    Yup, ok here goes. I insert the firing pin into a block of wood or a hole in a wooden table. Depress the firing pin by pushing the bolt...
  • D
    Dolomite replied to the thread Are Whidden Dies Worth It?.
    Whidden dies do not over size the brass vs rcbs or Redding which sizes the cases almost back to factory. Whidden does size the base a...
  • D
    Dolomite reacted to spife7980's post in the thread CCI 400 for 6BR class? with Like Like.
    Make sure you have a smaller .062 firing pin vs a larger .080, or at least a tight fitting pin the hole fitment. Helps the thinner small...
Show older items
Top Bottom
Back
Home
Forums
Merch
Alerts