Recent content by FCS

Large or small primer? Can’t tell for certain from picture which primer was used.

All brass fired in same chamber? Factory chamber or a custom chamber?

Appears to be sold, pending...

Post was mostly for humor.

Pics sent

MSTN - https://mstn.biz/ JP - https://www.jprifles.com/

What is maximum OAL that mag box will accept?

Don’t buy Redding competition shell holders, those are thicker, not thinner, so you’ll be moving in wrong direction. Find a machine shop with a precision grinder and have them take off 0.003” - 0.005” from a shell holder. I’d recommend marking that shell holder and having a standard shell...

Sinclair OAL tool works well, doesn’t require a modified case. What bullet are you using? What reamer did ‘smith use, can you get freebore dimension from ‘smith?

Should make a nice 13.9 - 14.5” upper…. Been wanting to try a 13.9-14.5 barreled upper, I’ll take the upper. Sending PM.

https://www.snipershide.com/shooting/threads/do-not-use-vibratite-hot-lock.7207846/ Not going to salvage threads. Run w/o muzzle device or cut down and have rethreaded as OP stated in post 1 & 7 update.

Suppressor on a Form 4 or Form 3?

Rifle or +2” gas system? Have a bolt? If no bolt, was headspace set for a type 1 or type 2 bolt? What barrel blank was used? How many rds down barrel, if any?

Fired from bolt gun(s) or gas gun(s)? Factory or custom chamber?

LC LR is about 1 gr less capacity than Lapua. Winchester is about 1.5 gr more capacity than Lapua. LC 72 Match will be roughly 2.5 gr less capacity than Winchester brass. I'd start about 2.5 gr lower charge weight then what Hodgdon calls out for Winchester brass in the LC 72 Match to get...