Recent content by gary55

thanx

Is it just me or something wrong with Aadmount's site? I've tried on 3 devices with no luck.

Electricity is made by burning...magic?

Well, I read it, pimpin 80's

Are they equal quality to a metal Accurate Mag?

The rifle came with an Accurate mag. I milled the insert today and just cycled 6 rounds without a hiccup. These are seated at 2.445 which is kissing the lands. I think I'll get another Accurate mag and be done.

I know some will disagree but those gauges are inconsistent. The video Rerun posted is the Wheeler method and gives the same measurement every time. I'm betting the glue/loctite method does too.

Thank you profusely. I don't have a single piece of 6BR to give you but I'll keep you mind. This method seems easier/faster than the Wheeler. I might give it a try next time. Thanks again, profusely.

I just watched a video that used red Loctite to find lands. It looks simple. Anyone doing that?

Dot3, How did you make out on this? Was it the same as Rem700? I'm about to find the lands on my Premiere, so gathering data.

$155, darn that's higher than giraffe... Has anyone used them?

First, my apologies for resurrecting this thread, I couldn't find the answer otherwise. The polymer MDT mags state a coal of 2.55, is this the longest known to date?

I'm going to take it work tomorrow and hone it out just a little and see if it smooths it off. If not, a new sizer is just over the horizon.

Took some photos with my bore scope. Almost looks like there's part of a neck busted off inside the die. When I run the camera in from the threaded end, where the decapping rod goes in, I don't see an edge though. This, if that's what's going on, had to have been there when I bought it. All my...

I have disassembled the die and can't see anything not normal. The die is not new, I got it used from a friend that stated this never happened to him. I personally have not seen it operate correctly. I'm not sure the neck thickness could be more than is given between the expander and die body...