Recent content by GoatPilot87

Thanks guys, I knew I was over complicating it. So to add to my question, use the same scenario above. I'm at 100yds, impact is 1mil left, I'm on 12x (again, a mil will be 7.2" at 100yds, I know...forget other measurements), so at 12x is it still 10 clicks right? I understand most all that I've...

Hey guys, I have a question about second focal plane scopes. I have a Sightron SIII 6x24 LRMD/CM scope on my Savage. This was the first mil/mil scope I've ever used or purchased. I've read tons about mils, equations, ballistic calculators, etc and watched and read a lot Frank has put up, and...

Re: Chris Kyle former seal murdered Read his book back in October during my honeymoon. How is it you make it through all that shit fighting to defend all of us here and some fucking nut murders him in his own country? Pray for his wife and children guys.

Re: Looking for smith in North Alabama I work on University Dr so I'm close to Athens somewhat anyway. Couple guys at work do a lot of business at Craigs. I'll drop by tomorrow after work and check out their powder too, MAYBE I'll luck out.

Re: Training results at 500 m on paper--Thanks SH! OP I've got a Savage 10 FP also, have you tried anything heavier than the 168's? Ive always shot Fed. GMM 168's too but Im just now getting into reloading and Ive loaded about 200 rounds with Hornady A-Maxs. Good shooting, keep it up.

Hey guys, I'm looking for a good smith to install a break on my Savage .308. Im located in Hazel Green, so the closer the better but if I have to drive a little thats fine. Thanks!