Hateca's latest activity
-
Hateca replied to the thread Gunsmithing ? On PTG Bolt Body.Are you accounting for the extractor riding over the rim? Not just after the extractor has seated over the case rim. Depending on the... -
Hateca reacted to LongRifles Inc.'s post in the thread Gunsmithing Remington 700 bolt question with
Like.
My opinion based on 28 years in this trade: There are 2 types of firearms enthusiasts. Those who have been fucked by PTG and those who... -
Hateca replied to the thread What China is saying about our "insurrection"..Well ABC News did say the Dems need to “cleanse“ the population of Trump supporters. Didn’t the Nazi’s try cleansing a population once?
-
Hateca replied to the thread Gunsmithing One shot before she goes in the trash.Take a pic of the bottom metal and the stock inlet. Tac Ops used Williams and Remington mostly, they work the same but there are slight...
-
Hateca replied to the thread Anybody visit the Accurate reloading forum? Wow, this is where Uncle Joe’s reloaders hang out..I read some of their post. Some scary stuff.
-
Hateca replied to the thread Gunsmithing One shot before she goes in the trash.stock doesn’t hold the box the box is sandwiched between the bottom metal and receiver. Tac Ops cut the stocks to use different bottom...
-
Hateca replied to the thread Gunsmithing One shot before she goes in the trash.What bottom metal and what model return stock? Put the box into the receiver then the entire thing into the stock. Then install the...
-
Hateca replied to the thread SOLD WTS: RH REM 700 SA AICS AX Chassis.PM sent.
-
Rugged Obsidian 45
-
Hateca replied to the thread Gunsmithing Chamber Reamer Wear.:ROFLMAO:(y)
-
Hateca reacted to gunsnjeeps's post in the thread Gunsmithing .260 Remington fat neck reamer for LC Brass with Like.
Brass catcher?
-
Hateca replied to the thread Gunsmithing Lapped lugs look good?.Do not use the barrel as a guide to lap. Do not use a fired case to lap. Do not lap with the firing pin assembly and trigger installed...
-
Hateca replied to the thread Gunsmithing Chamber Reamer Wear.Didn’t say it was, in fact I see no difference In reamer life. Dial in the barrel at the lead on throat you will almost always need to...
-
Hateca replied to the thread Gunsmithing Anyone pre-bore with the floating reamer holder?.I don’t do pre drilling and or boring any longer. The technique I use to dial in the barrel I found it didn’t same me any time and I...
-
Hateca replied to the thread Gunsmithing Chamber Reamer Wear.HSS is not ideal but will work. Start paying a little extra and get the carbide readers you will thank yourself. I think you just got a...