Recent content by hithard

  1. H

    Consealed Carry Chicago Style

    Did ya all read the comments, LOL....
  2. H

    Molon labe postcards -UPDATE NEED VOTES on design

    Re: Molon labe postcards four or five. Needs a line above it saying. I_______________ support an Uninfringed 2A Molon Labe Other wise one guy could send the whole batch, it needs a little individuality to each card. Pre printed address on it would be great.
  3. H

    sako 75/85 varmint 223

    Re: sako 75/85 varmint 223 Mine has a 12twist. I have had no luck with anything heavier than 55gr. not surprised but had to try. I've had good luck with 27.5gr. of varget and 52gr. sierra's. 50gr. ballistic tips have given good results too. I'm in the process of trying to work something...
  4. H

    168gr AMAX

    Re: 168gr AMAX What are you loading them with that you can get them out that far, barrel length? Thanks,
  5. H

    Rifle Scopes Vortex or other

    Re: Vortex or other what about the viper,
  6. H

    Rifle Scopes Vortex or other

    Looking at the Vortex, would like to try some of that long range stuff. Only have about five hundred to spend on the scope. FFP or Sfp...What do I need to do hear...
  7. H

    Rifle Scopes burris blackdiamond 4-16 50mm help

    I have this scope atop my 700p in 308. I have some interest in shooting a match. Question is, do I spend the money on getting the the turrets replaced, or do I just get another scope? Money is a bit tight. If a changing turrets who to do the work. Right now it's shooting .75 5shot groups or...
  8. H

    New Load...My Primers Look OK?

    Re: New Load...My Primers Look OK? Yes, well you either have a large hole or a small firing pin. In either case you should use caution working your loads up. Personally I would address it. Because if it isn't right, it must be wrong, right? Safety first, I would hate to hear you had a...
  9. H

    Gunsmithing 338 federal what twist?

    rebarrelling to 338 federal going with a 20 in tube, pac nor is going to do the work, just looking at twist rates, would like to go with 1-12 to shoot cast, but not sure if that will still stabilize the the 200 and 225 grain jacketed bullets. What does your experience say?
See more
Top Bottom
Back
Home
Forums
Merch
Alerts