Recent content by jakim0423

I am ready to order a new rifle and can't decide on what. What are your thoughts on the .416VM. I already have most calibers in the .338 and .375 range. I don't really care for the 50bmg or 416 Barrett. Any one have experience with this one. How will it compare to my 375ct. Thanks for your input.

I have not experianced any signs of pressure. I load mine with 2 starr Jamison 132gr retumbo Fed 215 primer and SMK 350gr. Out of a 30" Benchmark I am getting 3111fps with a spread of 9fps spread. The brass has one 3 loads so far. I have a 100yd zero with a 40moa base and NFAtacR. The farthest I...

I just had a custom LR delivered. It shoots great but tonight when cleaning I noticed the brake is about 15 degrees past zero so the ports are not straight across. I have unthreaded it a hundred times and can't get it to thread on so it sits horizontal. It is a long ways and very expensive to...

I just recived my new one. It's a .375 built on the Tac 408 1.45" repeater action with a 30" bench mark barrel. What is the prefered twist for this? Mine has a 1:10. Funny thing is I mounted the ATACr on it as well as installed it in an XLR chassis. Any one care to offer a little load data to...

Not sure what the rings are. The guy building my rifle is supplying them with the scope I also bought from him.

Why yes I am. But living in Alaska I do not have access to reloading supplies like everyone else because of the hazardous shipping issue. So I am flying down to another state for seven days were I can have access to various powders and primers to develop a load. As well as visiting family. So I...

I am looking for some load data. Here is what I am planning on. 350gr smk bullet 132 gr retumbo Federal 215 primer Jamison brass. Don't know the COAL yet. Should be around 3050ft/sec Any advice is appreciated. Should receive my new rifle in about 2 months.

Like I said I am new to long range but if my calculations are correct with the NF and a 40moa base I can have a 100 yard zero and have adjustment to go as far as the caliber capable of. Plus at 12-1500 yards I would be in the mechanical zero area of the scope. All comments are welcome.

I am about to recieve my new rifle it is a .375 Cheytac built on a Stiller Tac 408 action 30" barrel and an XLR chassis. I just recived my new NF ATACR scope and rings but wonder what base to put under it. I was thinking a 40moa base. Is that to much? I am just gettining into long range so the...