Recent content by JBomb

I have a WOA fluted SPR. It's shoots decent but it took a 100 round to come around. It took a few months to get it though. Here's a 3 shot group at 100 yards and a 5 shot group at 200 yards.

After dealing with cold hands for years, and scouring the earth for some miracle gloves. I've come to the realization that it's almost impossible to find a glove to keep my hands warm. Not to mention once my hands get cold, they couldn't warm back up. My solution....I always keep a second pair...

www.snipershide.com/shooting/forum/sniper’s-hide®-armory-supply/sniper-s-hide-semi-auto-rifles/6273840-224-predator

I feel the same way. Kind of a wasted build. The only benefit is being able to magazine feed an 80 grain bullet in a semi auto.

I have one I've been working on. I don't think 3100 fps is possible with temp stable extruded powders. I've been mainly playing with Varget and 8208xbr. I think I've finally settled on a load with Varget. I think the barrels are a good value and this is my second barrel from them. They seem to...

Here is my GA Precision 6.5 Creedmoor...

I can't find the picture right now but of the top of my head it was something like this.... 5.6 moa. 400 yard 10.2 moa. 500 yard 15.8 moa. 600 yard It's probably not exact but it's close.

GA Precision 6.5 Creedmoor Badger Ordnance M2013 KRG Whiskey 3

Double tap

Thank you for the kind words. I wanted a little more grip on the skid plate, so I stippled it. Kind regards, Jared

GA Precision 6.5 Creedmoor Badger Ordnance M2013 KRG Whiskey 3

I may be different than the rest of you guys, but I appreciate seeing some tits...and I don't think I've seen a bad set thus far (except for shanksters girls). The way I see it, it takes a lot of balls to bear all. I wonder how many guys here would readily drop their pants, and let the...

Does anyone know if the SWA 5.56 77 grain SMK load has crimped primers?

Yes, the tension screw did help. Although, it doesn't eliminate the problem...it just puts a little tension on the upper. Call me a stickler, but I don't like to see light through an upper/lower....and I think it gives an opportunity to let dirt and dust into the lower. The JP tension pin...

I'm not sure what most people feel is a "match fit", but I'm a little disappointed in my upper/lower fit. I have approximately .008 gap between my upper and lower. Although, the gun functions fine, I don't like seeing light between the two assemblies. Also, there is a considerable amount of...