Recent content by Jon S Van Niel

Re: forum length I was hoping the Yankee's were going to walk the winning run in, but I'll take the single.

Re: So...what's ur occupation? Audio visual production and staging. I'm in charge of the North American inventory.

Re: Reloading 101: Reloading basics for the new re Doc Actually you answered my question, too little is better than too much. I'll probably do a 1/3 to a 1/2 of what the internal flash hole is, mainly so I can write it down and double check every so often that the stop hasn't moved. It...

Re: Reloading 101: Reloading basics for the new re Doc Depth wise on the outside chamfer, do you just break the edge of the flash hole or match the inside flash hole deburring depth? My inside deburring tool measures .141, would I take this measurement then add the depth of the primer...

Re: Reloading 101: Reloading basics for the new re Doc76251 That is a great write up. It also answered a few question I had, and also raised one I didn't know about. How much do you chamfer the outside of the flash hole? Would I set the chamfer to match the inside? Thanks Jon