Recent content by JTknives

Wow that's a ton of holes for a ladder test. When I do a ladder test I load one round starting at my start load and steps in .5gr up to my max. I pick the range that has the least virtacle spread. I could care less right now about horizontal spread. I then work 3 shot groups from that and settle...

Are you guys full length sizing or neck sizing. I'm having issues with this bullet/powder combo and neck sizing.

Wonder if I can convert 270 brass into 308. All the stores have crap tons of Winchester 270 brass.

I have looked and looked everywhere and can not find Winchester brand 308 brass. I can find everyone else's brand, lapua, nosler, hornady, remingtion, HSM, ..... But no Winchester. Where is it?

Well guys I found the problem. I had 2 rounds of of fired brass I shot the other day that where loaded with the Speer book load (168gr Speer BTHP match + 45.3grs of W748 and a federal gold medal match magnum large rifle primer.). This load was stright out of there book #14. Onley thing that was...

I found a K of CCI200 primers and I'm going to try thoes. I wonder if thy will work better. From all my past reloading with pistols for accuracy I found that if I could use a standard primer over a mag primer I could count on about half the group size. So I'm hoping that these non mag primers...

I have been fallowing the big thread on using the 208gr amax in a 308 for a long time and now built a gun to do it. So I'm stocked up on bullets 600 of them and powder. I loaded some up from 43gr to 45gr, and my col is 2.900 my max is only 2.908 in this gun. I went out and tested and found that...