Recent content by just browsing

Why even take the chance? There’s zero justification to buy one when you have companies like Seekins that are cheaper, better quality, and will go out of their way to make sure customers are happy.

The action itself will fit fine, but the A1 chassis will only take short action CTR mags. I guess you could probably get a single shot follower or something that would work if you didn’t care about round capacity, but otherwise the mag inlet/length would be your main constraint.

I couldn’t tell a shit’s worth of difference in recoil reduction between Maverick and TBAC RR. Same rifle and ammo. There was a small perceptible difference in sound and tone, but neither of them would be considered “quiet.” A majority of guys would be hard pressed to tell which one they were...

I was the PO and can confirm everything here. Round count is right around 200, all of which were fireforming loads. Early accuracy returns were very good with little to no load development. I think Sawtooth also serializes their barrels - I’d imagine they’d be able confirm any specific...

A little duct tape and some channel locks. I’m not sure why everyone is so dumbfounded by AI bolt handles but they just thread right off like everything else.

Be strong brother you are not alone. This is a safe space. Gonna need one of these: https://lumleyarms.us/M6-M6x1-bolt-knob And then any 5/16x24 threaded knob you fancy. I got the brass bead from McMaster-Carr because I wanted something thiccc and girthy.

More pics less talk, nerds This is the new new ghey-TX

I’ve used MDT .308 and BR 12-round mags in my ATX with no issues. As Lenny said, not as smooth as the AX mags, but I didn’t have any issues with them either. For GT I found that sliding the rounds slightly forward to the shoulder in AX mags worked best for me.

Have a brand new Kelbly Prometheus action with .223 bolt that I would like to trade for a Terminus Zeus .223 action with full length tenon. The Prometheus is unbelievably smooth, just moving everything over to 60 deg throws.

Hope you’ll be shooting it suppressed. 16” large frames are for masochists.

The 40* shoulder and case taper (lack thereof) is exactly why it’s generally more consistent.

I heard someone dragged some NRL skull with one of these bitches at the Arena match last weekend.

No that was before I had the rail installed. Here it is with the rail. Kinda shows you what I was talking about in front of the magwell… there’s a little step-down that creates a small gap. You could remedy that entirely by pushing the rail out further towards the muzzle. I just wanted the...

Yes you are correct - it’s a pro varmint. Picked it up as a project stock needing a lot of work… drilled out and installed pillars, cleaned up the inlet and recoil lug area, and opened up the barrel channel. Bedded the bottom metal and action with MarineTex, and then new paint on top of all...

Had a .223 barreled action sitting around so I picked up a cheap Boyd’s stock and decided to do my own take on a Super Varmint. Completely bedded and refinished. Have since added Waters Rifleman 10-round mags and an SRS full length Arca rail. 75 ELDs around 2950 🤌🏻🤌🏻