Recent content by Kentucreed6

5. I just checked. Sorry for the delay

Bump

30” blank Hart 7 twist, 6mm 1.2 straight contour. Will do $325 shipped to you, PayPal FF.

Up

Up

Selling a Faxon FX7 action 308 bolt face. In like new condition. I bought it to run my Terminus Zeus barrels on as a back up. It does headspace correct. It’s just not a Terminus and not the same feel at all so I’m looking to sell it. Pm any questions. $750 shipped PayPal FF

FX120i scale with 419 platen and cup. Has windscreen sides but not the top. Works like it should. Has been used with Also will come with 100g check weight. $500 shipped. PayPal FF

I know for a fact .253 you will have to neck turn. I have a .253 reamer. I’ve shot some unturned brass to fire form and it still easily hold a bullet after firing.

I asked the same thing earlier, with no reply. If you find out it will work let me know

Ingenuity trickler and FX120i scale. Area 419 cup and platen. Has V3 Bluetooth. What I have as far as accessories for the scale are pictured. I don’t have the top for wind screen any more. Looking for $850 shipped on this package. PayPal FF

T6A Elite 700 SA with KMW bottom metal. Stock is bedded for 700 SA, but I have run my Terminus and an Origin in it with no problem because there is no bedding in front of the recoil lug. Can run a 1.2 straight profile in it. Comes with 419 rail and all associated parts for it. Weighs right a...

I did use AW mags. Also used ARC mags and MDT and accurate mags. With a 22 Bra barrel and 6x47 Lapua barrel. Bottom line is it doesn’t feed well. Even worse with the center feed mags because the bullets hit the center portion of the feed ramp. It causes the rounds to be pushed to the side some...

Yeah, I get the same. The feed ramp sucks. It’s shaped like a M4 feed ramp and is too steep and split in the middle. If it was a single smoother feed ramp with less angle it would be much better. Straight up the feeding sucks ass. I’m actually not happy at all with the bolt operation and feeding...

As far as opening a closing, the bolt is smooth and the timing for primary extraction is good. The down fall is making sure that alignment when pushing the bolt forward is good. Without the typical raceways for the lugs to ride in for the full length of the receiver it can get slightly off...

Action is nicely machined, I got the matte finish. It's really a good looking action. One nice little feature is the indexing mark on the front for barrels if a guy wanted to have indexing lines to match up. Compared to my Terminus Zeus I think the bolt lift is a but stiffer for those that...