Recent content by lennyo3034

Was going to say this. Inception and predators off the top of my head. Not sure what else.

Thinking of picking up a factory rifle in 6mm Creedmoor. Looking to shoot factory division. Obviously not going to make 380 power factor. Do I have to shoot factory ammo? I read power factor does not apply to factory division so can I shoot handloads?

No, I used the .308 size mags. Those worked for me (not the smoothest but they worked). I have not tried the 6BR mags. @just browsing has tried them too.

I like the wings. Polymer or metal?

I use 180eldm a in a 7mag and retumbo. 30” barrel is putting me at 3030fps. 1-8 twist. Problem is at that twist rate about 5% of my bullets are blowing up midair. Jackets are not holding up. However transonic stability is also bad, so once it hits transonic, it start tumbling. Out to 1500...

FWIW my AX mags did not feed 6GT very well in AT-x. Nosedive issues into the mag. Tried a MDT 12rounder AICS mag and works perfect.

Wait really? I have a 40x titanium SA I was just about to send off to get cut on (side bolt release,cerakote). Maybe I should rethink that.

I’ve had ports that look way worse than anything in this thread and the barrel still shot amazingly.

I'll take the 30 cal.

I’ll take it

This was a carbon fiber wrapped blank? How was the gas port done? A block like proof does it making it gas gun specific?

I'll take them.

Shot the 2 day matches with gasser last year. Switched to bolt gun in open this year and while my scores are better I don't seem to be having as much fun. Likely going back to gas gun next year. Need to see if JP will put a Craddock barrel in one of their otherwise complete builds. I'm actually...

Form 4 trust efile submitted 8/18/22 Still pending

I seen you put the whole turkey in that chili.