Recent content by lizzardking308

Might have a 6.5CM 24” I’d move…

Mine. Funds enroute. Thank you!

PM sent on the last one.

Mullerworks or Proof for carbon wrapped.

SOLD

Jeff will do Bartlein. Some of the best. http://www.riversbendguncompany.com/

I think I heard they bailed on their support for the NRA? Can someone confirm?

Keep in mind a bedding job is needed for a McMillan to get the best performance whereas a Sage is bolt in and go. Not a slight against the McMillan, just a consideration.

I honestly never shot it with the Archangel stock mine came with, I immediately dropped it into the Sage as I had one laying around. I personally like the ergo’s of the Sage and found that I could dial in loads that were Sub MOA with them so I’ve never looked at anything else. The only downside...

I’ll dissent here. I have two M1A’s setup for long range and both are capable of sub MOA performance should the idiot behind the gun do things correctly. They can be very humbling should one slack off on whole “marksmanship” thing....... One of mine is a SAI loaded dropped in a Sage EBR and...

MWS hands down. Go with a stainless barrel for ultimate accuracy, but it’s hands down a better system than the DD. If you want stupid accuracy get a custom barrel from Rivers Bend and you’ll be set.

Call Marty at Badger. You won’t be disappointed. Awesome actions for sure.

Sigh... this again...

With an 18” SS barrel on my MWS it’s a hammer out to 830, which is the farthest I’ve taken it. While printing small groups is fun, I have bolt rifles for that purpose. My rifle will shoot sub MOA to distance so long as the moron behind it does his job. The MWS is a battle rifle where a...

Whoa... holy necropost.... that being said, I polished the expander ball down so I have 0.003 neck tension. Works just fine for me.