Recent content by LRshooter6mm

Is there much play in your ejector when it’s in?

Only have the KRG unfortunately

Everything is set except now I it won’t eject any rounds. It appears when I run the bolt back the magnetic ejector plate dips just enough for the round to slid over and not to eject. When I remove the mag and push hard on the bottom of the ejector plate it will then eject. Any advice? I have...

I found some double threaded lh and rh stud and some lh nut. I’ll give it a try. How is the center portion pinned to the screw shaft?

Thanks, I’ll see what I can find in that regards

I’m trying to design and 3D print a part for a picatinny rail clamp that acts like the Really Right Stuff VYCE where both clamp walls move in or out from turning the knob. I’ve been looking at different version and some utilize an inner and outer threaded bolt and I just cant wrap my head around...

It does with with the WTO switch lug. Midwest Shooting did a review of it on YouTube

Customer service is not ideal, but if you hound Curtis he will get stuff to you. I knew that going into it so I was patient but I get why others were so frustrated. People who use QC have had zero issues as long as they take proper precautions. I didn’t not and plan on using a barrel vice since...

I own one for my Valor. Need to install my trigger tech since it didnt like the Timney. Check out this forum -https://www.snipershide.com/shooting/threads/curtis-custom-22lr-conversion.6979494/page-3#post-11503898 Lots of good info

Just got the ejector plate finally. Either I’m an idiot or it’s not fitting in my KRG whiskey 3. Any tips? Did you have the action removed from the chassis before install?

Based on the designation in the website, looks like it is private. But there is a bunch of BLM surrounding it so it’s possible there could be some long range targets on the BLM land

Found someone, thanks for the reply 👍

Looking for anyone who has ROed the Gunwerks NRL Hunter Match recently. Shoot me a PM.

Just received my valor from the FFL. Chase didn’t send a mag or the ejector with it so it will be another little bit. I might get impatient and single feed it so I can shoot it lol I’m not convinced my Timney will cut it. I’ve heard it’s hit and miss with light primer strikes in a Curtis so...

Did you have any fitment issues with the magnetic ejector with the bravo? Looks like a sweet build!