Recent content by Mareshow

Mostly coyote hunting 250m (approx 300 yds) and in. ID beyond that would be nice. I like the idea of a clip on because I could helmet mount it as well. Unfortunately most things are ITAR restricted so I'm stuck with infiray's line up. another large issue is night hunting is technically...

this is exactly the type of feedback I'm looking for. for Clip on I would use it on two optics a 1-8 LVPO (on a 223) as well as potentially a PMII 5-25 (on a multi cal, but primarily 300 PRC), though my issue with this is I've read 5x on the low end might be too high of magnification for a clip...

Just wondering what the typical engagement distance is for thermal predator hunting for most? During the day here we typically shoot them anywhere between 50 m and 200 m. I'm trying to decide between putting a clip on in front of an LVPO or running a dedicated thermal scope. so far the YT...

Fondled one of those yesterday. Is that the stock mount that makes it sit up so high on the rail? Be nice if it sat a little lower. Has any one thought to mount on the side of the forend? I have carried for coyotes in an eberlestock backpack and it was fine, sling wise I have a padded backpack...

They are the NF low rings .885" I had MDT low rings but they were a bit lower and the scope actually hit. Id go with the 1" ones though as it'll allow a little more movement in the scope for mounting. with these there's basically only once position you can put the scope in.

at 500m there is a .5 mil difference

One bad batch of receivers and they are all junk... Its not like AI had any problems in the past... oh wait I went MRAD. And frankly I think I like the bolt manipulation more than the AI Would I sell all my other rifles and only use this one? no probably not but it fills a void in my...

Very possible imo, carbon barrel or lighter contour, NX8 or vx6, I’d go NF ultralight rings and you should be right there

Just weight in at 16.5 lbs as configured, it’s basically a bull barrel under there so she’s got some heft Accurate as all get out though, first round hits at 800 yards The Canadian distributor for Barrett, dumb part is i can import the kit cheaper direct from the states and have it in three...

Got My 308 Shorty. Probably going to rattle can it. Overall I'm very impressed! 300 PRC barrel is on order, apparently its going to take 12-18 months :confused:

Browning has some great options if you can get over the trigger. I just sold one that was easy sub moa with factory 212 eldx

I've Heard people compare the Zeiss LRP S3 to the NX8. Most say the S3 has better glass but I have no first hand experience with one

Load an AW mag then load a DT mag and then get back to me. Barrett Mags would be similar to the AW mags I'd assume. AICS aren't bad but the DT mags how they ramp on the shoulder is kinda a PITA. I know because of that they feed well but it's just annoying. That actually a great idea! my 3D...

I want to like the DT so bad but the mags... they just let the whole system down. I can get over the bolt and bolt feel. But those mags.... Why must they be that way.

I seen a few instances of it happening but Barrett claimed it was a bad batch of aluminum, The ones I seen were quickly remedied Let's not forget that AI has had its problems too. Hence me waiting 8 months for a new bolt