Recent content by MediumSpeed

Nice 😂🙂 looks a bit like Limalama. If it is, orange belt is the first rank you earn after white (between 4 and 6 months of training) so all the folks are quite beginers at this point in their training.

I just got one as well - so far it's awesome (previous I was priming on a dillion 650 - this is faster with depth control)

Hum - i used a surefire one that locked to special lights they make. It covered the trigger but the rest of the gun was exposed. Worked for my glock and 1911. Having the suppressor on the gun (a SiCo K45) made it a bit wiggley so that if you moved quickly a hot can might kiss your leg...

The 21 century ones work as well

Does your AR-10 or 300blk have an adjustable gas block? If not, you might consider a flow through technology design like the Hux so you have overgassing issues.

Bought this for my 650 based on this thread, thought I would give it a try - works well, easy install and remove, not quite as good as cutting crimps with a RCBS or Hornady cutter (had about 5 primers get stuck/caught out of 300 rounds) but _way_ faster - worth the time saving for blaster ammo.

I run the Omega on gassers with an adjustable gas block - typically Noveski switchblocks - as long as the flow is reduced for suppressed it is fine but if I leave it on regular I get malfunctions from the over gassing

No tips, I have a folded small post-it under the front legs tilting it back slightly (maybe a hundredth of a inch...). It also sits on a piece of marble to minamize vibration. I just calibrate and go.

I have the previous gen OSS 7.62 ti can that I use on 223/65cm/308 gassers that dont have adjustable gass blocks and it is great. Comparing to the SiCo Omega 300 on my bolt gun ~ similar sound reduction... I wouldn't shoot either all day without some level of ear pro...

I haven't had any issues. I don't have the jthor tip - I throw (threw?) a lot of H4350 (42.8gr) for my 6.5cm with very few over throws.

Mine took 6-8 months - I think there were some issues with getting the chips/parts to build them.

I load a lot of 223 and 9mm on a 650 - overall I'm quite happy with it - for "accurate" 223 I use same lot brass and a fine ball powder for the volumetric podwer drop. For training ammo (made from range pickups) most of the 223 and some of the 9 need their primer pockets reamed/swaged, a 1050 or...

I like powdervalley.com in addition to midsouth. Brownells is good though a bit more expensive. Sometime if I have to I'll use ammoseek to look for primers or a particular bullet...

I'm not home at the moment. I think the inner diameter is 1/4" but I'm not 100% sure - sorry.