M

Mike_R

Full Member Minuteman
Private
Messages
83
Featured content
0
Reaction score
3
XP
6
Level
1
Joined
Last seen

Latest activity Postings Featured content About Feedback Stats

    • M
      Mike_R reacted to 1911Shootist's post in the thread Coating after AW Cut with Like Like.
      I had mine cut 2 years ago and left uncoated. It’s still mint.
    • M
      Mike_R reacted to W6SPK's post in the thread Coating after AW Cut with Like Like.
      It is just a minor notch cut on the bottom side
    • M
      Mike_R replied to the thread Coating after AW Cut.
      You are probably right, the only reason I haven't done it yet is more of a matter of principal. I'm in CA and so on top of the various...
    • M
      Mike_R replied to the thread Coating after AW Cut.
      Mine is an AICS cut version I bought back in early 2022. It sounds like I am overthinking it. I had bugged Tate a year ago about it...
    • M
      Mike_R reacted to W6SPK's post in the thread Coating after AW Cut with Like Like.
      They are all AW cut now, but previously most were AI and you would have to specify AW.
    • M
      Mike_R reacted to spife7980's post in the thread Coating after AW Cut with Like Like.
      They werent initially, you could choose which. They have since defaulted to all aw the last few years since it accommodates both.
    • M
      Mike_R reacted to W6SPK's post in the thread Coating after AW Cut with Like Like.
      I was considering sending my impact in and I had the same concern, this was Greg's response when I asked about refinishing after the...
    • M
      Mike_R reacted to spife7980's post in the thread Coating after AW Cut with Like Like.
      Id just sharpie or spray paint it and call it good. When you have it out of the stock once or twice a year give it a little oil wipe, it...
    • M
      Mike_R reacted to ShtrRdy's post in the thread Coating after AW Cut with Like Like.
      I think I would look into seeing if it could be nitride again. Cerakote is nice but I think would wear out from cartridge feeding and...
    • M
      Mike_R replied to the thread Coating after AW Cut.
      I think most of them are 400 series stainless, the martensitic stainless steels which aren't all that corrosion resistant. I've had 410...
    • M
      Mike_R reacted to Mulepackhunter's post in the thread Coating after AW Cut with Like Like.
      If you have any access to cold blue try it in a small spot and see if it reacts, if it doesn’t do anything then your good to go raw...
    • M
      Mike_R posted the thread Coating after AW Cut in Bolt Action Rifles.
      I've got an Impact 737 I am thinking of sending in to get cut for AW mags. Corrosion resistance is pretty important where I am at...
    • M
      Mike_R reacted to GeoDude's post in the thread I Spy New Baby Razor G3 4-24 with Haha Haha.
      I just pre-ordered through Iibertyoptics, can’t wait.
    Show older items
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top Bottom
Back
Home
Forums
Merch
Alerts