Recent content by morano
-
-
-
SOLD Hornady 30 cal ELD-M bullets
I'll take them if they are still available pm sent- morano
- Post #4
- Forum: Buy - Sell - Trade
-
Accessories Rune Tactical Canik Rival-S springs
I'll take these if they are still available "Hornady 224 73g ELDM (95 left) - $20 Hornady 224 80g ELDM (300 same lot) - $65" pm sent- morano
- Post #2
- Forum: Buy - Sell - Trade
-
Easiest way to chamfer inside of necks
A Harbor Freight drill press with depth stop set on the slowest speed. Chuck your VLD chamfer tool in and have one boy raise n lower it while the other swaps out the brass. Make a v shaped guide that can be bolted down to the table so the position of the brass is in the same place every time.- morano
- Post #9
- Forum: Reloading Depot
-
SOLD Remington 700 LA
A couple of questions.... - how thick is the recoil lug? - have the barrel tenon threads been cut oversize or are they factory dimension? - what is the serial # prefix letter? Thanks- morano
- Post #2
- Forum: Buy - Sell - Trade
-
Accessories Bartlien 6.5grendel Barrel
How many rounds thru it? Threaded 5/8-24 on the muzzle? Thanks- morano
- Post #3
- Forum: Buy - Sell - Trade
-
Accessories Early spring clean out
Put me down for seconds on these "LaRue Tactical MBT-2S trigger BNIB $75 each or both for $140 shipped"- morano
- Post #9
- Forum: Buy - Sell - Trade
-
Gunsmith for barrel chambering
A few more recommendation for gunsmiths with good reputations here in Texas Twisted Precision in Center Point Tx Crossroads Precision Rifles in Victoria Tx- morano
- Post #14
- Forum: Bolt Action Rifles
-
Accessories Sold * Leupold backcountry 20 moa rail, Remington 700 short action. $35 tyd
I'll take this if still available pm sent- morano
- Post #3
- Forum: Buy - Sell - Trade
-
SOLD WTS: Accurate mag 308 5rd
Does it have the front binder plate? Thanks- morano
- Post #2
- Forum: Buy - Sell - Trade
-
Help Identification of a stock.
I don't think McMillan ever used an aluminum bedding block- morano
- Post #10
- Forum: Bolt Action Rifles
-
Help Identification of a stock.
Looks like a Bell & Carlson M40 with a custom paint job It may also be a Rem 700 LongRange Hunter take off ( supplied by Bell & Carlson I believe) Does it have anything on the recoil pad?- morano
- Post #4
- Forum: Bolt Action Rifles
-
SOLD WTS: CZ 457 barrel and stock
If it's chambered for 22 long rifle ammo, I'll take it pm sent- morano
- Post #2
- Forum: Buy - Sell - Trade
-
Suppressors Cleaning AL .22 Baffles, Soak, Soda Blast, or?
I just recently picked up my Rugged Mustang. I took it out and put about a hundred rounds thru it. Later I took it all apart, sprayed the baffles down with CLP , let it sit, and wiped them all down. They didn't have any buildup, I am also wanting to find out what others use on aluminum...- morano
- Post #2
- Forum: The Armory
