Recent content by mountainman308

Sounds like someone with a 3D printer and some time could make a bit of money here

Do you want to have to get all that residue off your chassis once you get home?

Has anybody made/printed plugs for the ports in the action above the clamping screws. I’m prepping for a trip out to the Rockies and I’m thinking about ways to keep sand and crud out of the shank flutes and action block during a hike.

What projectiles were you planning on shooting out of the 300 NM with the 1/7 twist?

Mil/mil

Are you open to trades? I’ve got a NIB NX8 4x32.

I have run my SRS A2 with a 20 inch 6.5 Creedmoor barrel at the GAP grind, the Major Land Sniper Cup, and a handful of local club matches. At times I have shot poorly and at times I have shot well. When I shot poorly I can tell you, it wasn’t the rifle’s fault. There are distinct advantages to...

6.5 CM

That’s the ERA-Tac 20 mil adjustable scope mount (https://www.eurooptic.com/ERA-TAC-Gen-2-Adjustable-Inclination-Mount-34mm-Height-20mm-Nuts-0-20-MRAD-T5074.aspx). It’s a 20 inch barrel so having the extra elevation easily at hand is helpful. The box on the front of it is a MantisX that I use...

130 grain ELDM across the top of the heart. It dropped where it stood and didn’t even twitch.

The SRS A2 drops another deer in its tracks. A very respectable 8 point in this area. I threaded an ELDM across the top of his heart and he crumpled where he stood at 110 yards. He was also quartering away so while I lost some rib meat I think I saved both shoulder roasts!

How many hours do you have on it, and are you open to trades?

If I had the cash I would take it, but I don’t have cash. Just an NX8 I got off a prize table at a match. It’s a great set up!

Hahaha, fair enough. I’m in the same boat except I am still looking for my first thermal. A used C35 is at the top of my list. Good luck with the sale.

Would you take a trade on the c35? I’ve got a NIB NX8 4x32. Can provide details and photos if interested.